SERVICE AND ADJUSTMENTS
TERMINAL ACCESS DOOR
TERMINAL GUARD
KEPS NUT
HEX
BOLT
POSITIVE (RED)
CABLE
NEGATIVE (BLACK)
CABLE
ENGINE
TO ADJUST THROTTLE CONTROL CABLE (See Fig. 30)
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
• | With engine not running, move throttle control lever to |
| fast position. |
• | Check that swivel is against stop. If it is not, loosen |
FIG. 28
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 29)
•Raise hood.
•Unsnap headlight wire connector.
•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
•To replace, reverse above procedures.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 29
cable clamp screw and pull cable back until swivel is |
against stop. Tighten cable clamp screw securely. |
STOP
SWIVEL | CLAMP |
| SCREW |
FIG. 30
TO ADJUST CHOKE CONTROL (See Fig. 31)
The choke control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
•With engine not running, move choke control (located on dash panel) to full choke position.
•Loosen knob and remove cover assembly from air cleaner.
•Choke should be closed. If it is not, loosen casing clamp screw and move choke cable until choke is completely closed. Tighten casing clamp screw securely.
•Replace air cleaner cover assembly and tighten knob.
24
