OPERATION
SPARK | ENGINE OIL CAP | AUGER | DISCHARGE CHUTE CONTROL LEVER | |
PLUG | WITH DIPSTICK | CONTROL |
|
|
SAFETY |
| LEVER | DRIVE SPEED | DEFLECTOR REMOTE |
IGNITION |
|
| ||
|
| CONTROL LEVER | CONTROL LEVER | |
KEY | GASOLINE |
| ||
|
|
| ||
|
|
|
| |
| FILLER |
|
|
|
| CAP |
|
| TRACTION |
CHOKE |
| CHUTE |
| |
|
| DRIVE | ||
DEFLECTOR |
| |||
CON- |
| CONTROL | ||
|
|
| ||
TROL |
|
|
| LEVER |
THROTTLE / |
|
|
| LH TURN |
ENGINE |
|
|
| TRIGGER |
CONTROL |
|
|
|
|
|
|
| OIL DRAIN |
|
|
|
| PLUG | LIGHT |
RECOIL | POWER |
|
|
|
(AUXILIARY) |
|
|
| |
CORD |
|
|
| |
STARTER | PLUG | ELECTRIC |
|
|
HANDLE |
|
| ||
|
|
| ||
|
| START | FUEL | HANDLE |
|
| BUTTON |
| KNOB |
|
|
| DISCHARGE | |
PRIMER |
|
|
| |
|
|
| CHUTE |
|
|
|
|
| MUFFLER |
NOTE: ITEMS ABOVE |
|
| TOOLBOX | |
ARE SHOWN IN |
|
|
|
|
THEIR TYPICAL |
|
|
|
|
LOCATION ON THE |
|
|
| |
ENGINE. ACTUAL |
|
|
| |
LOCATION MAY VARY |
|
|
| |
WITH THE ENGINE |
|
|
| |
ON YOUR UNIT. |
|
|
|
|
SKID PLATE
AUGER
FIG. 11
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
LH and RH turn triggers - used to steer the snow thrower.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Deflector remote control lever - used to change the distance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
9 ground.
