SPinching the saw chain along the top of the guide bar may push the guide bar rapidly back toward the
operator.
SEither of these reactions may cause you to lose control of the saw which could result in serious injury.Do not rely exclusively upon the safety de- vices built into your saw.
The following guide bar and chain combina- tions meet kickback requirements of CSA Z62.1, Z62.3, & ANSI B175.1 when used on saws listed in this manual. Use of bar and chain combinations other than those listed is not recommended and may not meet the CKA requirements per standard.
Computed kickback angle (CKA) Table
| BAR |
|
| CKA without | CKA with |
|
|
|
| chain brake | chain brake |
MODEL | P/N | Length | CHAIN P/N | ||
295 | 952044578 | 18” | 952051313 | 21_ | 12_ |
|
|
|
|
|
|
NOTE: This saw complies with Federal OSHA regulations for commercial logging. SAFETY NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An
SPECIAL NOTICE: Your saw is equipped with a temperature limiting muffler and spark arresting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require many internal combustion engines to be equipped with a spark arrestor screen by law. If you operate a chain saw in a state or locale where such regulations exist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. Refer to the CARE AND MAINTENANCE section for maintenance of the Spark Arrestor.
Failure to follow all Safety Rules and Precau- tions can result in serious injury. If situations occur which are not covered in this manual, use care and good judgement. If you need assistance, contact your Authorized Service Dealer or call
The assembly tool provided with your saw is the only tool needed for assembly. Pro- tective gloves (not provided) should be worn during assembly.
ATTACHING THE BAR & CHAIN
WARNING: Recheck each assem- bly step if the saw is received assembled. Al- ways wear gloves when handling the chain. The chain is sharp and can cut you even when it is not moving!
SLoosen and remove the clamp nuts and the chain brake from the saw.
SRemove the plastic shipping spacer (if present).
Location of shipping spacer
Clamp Nuts
Chain Brake
Assembly Tool
SAn adjusting pin and screw is used to ad- just the tension of the chain. It is very im- portant when assembling the bar, that the pin located on the adjusting screw aligns into a hole in the bar. Turning the screw will move the adjustment pin up and down the screw. Locate this adjust- ment before you begin mounting the bar onto the saw.
6
