ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping pur- poses.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) | 3/4" wrench | (1) | Utility knife |
(1) | 9/16" wrench | (1) | Pliers |
(1) | Tire Pressure Gauge |
| |
When right or left hand is mentioned in this manual, it means from your point of view, when you are in the operat- ing position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton .
•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.
•Remove mower and packing materials.
•Check for any additional loose parts or cartons and remove.
A
FIG. 2
NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
CHECK BATTERY (See Fig. 1)
•Lift hood to raised position.
NOTE: If this battery is put into service after month and year indicated on label (L) (label is located between terminals) charge battery for minimum of one hour at
L |
02931
FIG. 1
ADJUST SEAT (See Fig. 2)
•Sit in seat.
•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.
•Release lever to lock seat in position.
TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)
•Raise attachment lift lever to its highest position.
•Release parking brake by depressing brake pedal.
•Place freewheel control in disengaged position to dis- engage transmission (See “TO TRANSPORT” in the Operation section of this manual).
•Roll tractor forward off skid.
TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)
•Be sure all the above assembly steps have been com- pleted.
•Check engine oil level and fill fuel tank with gasoline.
•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).
•Sit on seat in operating position, depress brake pedal and set the parking brake.
•Raise attachment lift lever to its highest position.
•Remove key from bag and start the engine (see "TO START" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.
•Release parking brake.
•Slowly depress forward drive pedal and drive tractor off skid.
•Apply brake to stop tractor and set parking brake.
•Turn ignition key to "STOP" position.
Continue with the instructions that follow.
6
