Poulan 96198002500, 424549 owner manual Storage, Carburetor, Engine Speed, Fuel System, Engine OIL

Models: 96198002500 424549

1 40
Download 40 pages 31.81 Kb
Page 17
Image 17

SERVICE AND ADJUSTMENTS

TO REMOVE WHEELS (See Fig. 22)

Remove the klik pin and remove wheel from axle.

IMPORTANT: When installing wheel, be sure to use the in- nermost hole in axle and the wheel hub hole. To disengage drive system from the wheels (for pushing or transporting the snow thrower), remove klik pin from wheel hub and insert pin into the outermost hole in axle only.

KLIK PIN

OUTER HOLE

 

INNER

 

HOLE

WHEEL

WHEEL HUB

FIG. 22

NOTE: To seal punctures or prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

ENGINE

See engine manual.

CARBURETOR

Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 7,000 feet (2,134 meters). If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center.

ENGINE SPEED

Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the engine-governed high speed needs adjusting, contact a qualified service center, which has proper equipment and experience to make any necessary adjustments.

STORAGE

Immediately prepare your unit for storage at the end of the season or if the unit will not be used for 30 days or more.

WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. Allow the engine to cool before storing in any enclosure.

SNOW THROWER

When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire snow thrower (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See “TO RE- PLACE BELTS” in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

ENGINE

See engine manual.

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in min- imizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

17

Page 17
Image 17
Poulan 96198002500, 424549 owner manual Storage, Carburetor, Engine Speed, Fuel System, Engine OIL

96198002500, 424549 specifications

The Poulan 424549,96198002500 is a versatile and reliable tool designed for outdoor maintenance and gardening tasks. This model stands out for its combination of robust performance and user-friendly features, making it an exceptional choice for both amateur gardeners and professional landscapers.

One of the main features of the Poulan 424549 is its powerful engine. It is equipped with a reliable two-cycle engine that provides ample power to tackle a variety of tasks. This engine design not only enhances performance but also ensures efficient fuel consumption, allowing users to work longer without the need for frequent refueling.

The lightweight design of the Poulan 424549 adds to its usability. Weighing significantly less than many competitors, this model allows for easy maneuverability, reducing user fatigue during extended periods of operation. The ergonomically designed handle also contributes to user comfort, providing a secure grip and minimizing vibration, which is crucial during longer work sessions.

Another notable feature is its advanced cutting technology. The Poulan 424549 integrates a sharp, durable cutting blade that is designed to slice through grass, weeds, and light brush with ease. This blade is not only effective but also designed for easy maintenance, allowing users to keep it in optimal condition with minimal effort.

Furthermore, the Poulan 424549 boasts a simplified starting system, which is an essential characteristic for users who value convenience. This system allows for quick and hassle-free starts, eliminating the frustration that often accompanies starting outdoor power equipment.

Durability is also a key focus in the design of the Poulan 424549. Constructed with high-quality materials, this model is built to withstand the rigors of outdoor use. Whether facing rough terrain or adverse weather conditions, users can rely on the Poulan 424549 to perform consistently.

Lastly, the Poulan 424549 comes with user-friendly maintenance features. Its easy-access air filter and spark plug make routine maintenance tasks straightforward, ensuring that users can keep the tool in excellent working condition without unnecessary complexity.

Overall, the Poulan 424549,96198002500 is an exceptional choice for those seeking a reliable, powerful, and user-friendly outdoor tool. With its robust engine, ergonomic design, advanced cutting technology, and emphasis on durability, it provides everything needed to maintain gardens and yards effectively.