OPERATION
MUFFLER
GASOLINE
FILLER CAP
CHOKE
CON-
TROL
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
PRIMER
FUEL
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
AUGERS
ELECTRIC AUGER
START CONTROL
BUTTON LEVER
POWER
CORD
PLUG
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
FIG. 10
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED | DEFLECTOR REMOTE |
CONTROL LEVER | CONTROL LEVER |
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
DRIFT
CUTTER
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine. ON / OFF switch - used to STOP the engine.
Drift cutter - used to cut through deep snowdrifts.
LH and RH turn triggers - used to steer the snow thrower.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the direc- tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground
Deflector remote control lever - used to change the distance the snow is thrown.
9
