OPERATION
GASOLINE
FILLER CAP
MUFFLER
CHOKE 
CON-
TROL
PRIMER
SAFETY
| AUGER | DISCHARGE CHUTE |
|
ELECTRIC | CONTROL LEVER |
| |
CONTROL |
| ||
START BUTTON |
|
| |
LEVER | DRIVE SPEED |
| |
|
| ||
RECOIL |
| CONTROL LEVER | TRACTION |
|
| ||
(AUXILIARY) |
|
| DRIVE |
STARTER |
|
| CONTROL |
HANDLE |
|
| LEVER |
| CHUTE |
|
|
DEFLECTOR |
|
| |
|
|
| LIGHT |
IGNITION
KEYON / OFF SWITCH
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
DISCHARGE
CHUTE
FIG. 8
CHUTE DEFLECTOR KNOB
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine. ON / OFF switch - used to STOP the engine.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the direc- tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
8
