Repair Parts, Axle Shaft, Roll PIN 3/16, Sprocket

REPAIR PARTS	SNOW THROWER - MODEL PP291E30 (96198003001)
DRIVE
		5
		6
	1b	4
	7	3
		3
	1b
6		1a

			KEY	PART
		2	NO.	NO.	DESCRIPTION
		3	1	188226	(assy of 1a,1b) AXLE ASSEMBLY
5	4		1a	179352	AXLE SHAFT
5	4	01.03.005-B	1b	9465M1	ROLL PIN 3/16
		01.03.005-B	2	402691	SPROCKET
			2	402691	SPROCKET
			3	174697	THRUST WASHER
			4	179830	BEARING
			5	17490508	BOLT 5/16−18 X .500
			6	155443	CLIK PIN
			7	189282	SQUARE KEY

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 34

Image 34

Poulan 435555, 96198003001 owner manual Repair Parts, Axle Shaft, Roll PIN 3/16, Sprocket, Clik PIN

Contents

Model Number Snow Thrower Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper Handle Install Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Install Chute Deflector Remote Control See Figs Install Discharge Chute / Chute Rotator Head See FigCheck Tire Pressure Primer OperationKnow Your Snow Thrower Ignition KEY Meets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting engine To USE Fuel SHUT-OFF Valve See Fig HOW to USE Your Snow ThrowerStopping To USE Choke Control See Fig To Throw Snow See Fig Using the CLEAN-OUT Tool See FigTo Adjust Skid Plates See Fig To Move Forward and Backward See Fig To USE Drift Cutters See Fig Before Starting the EngineScraper BAR See Fig Check Engine OIL Level See Fig Before Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has Frozen Maintenance Cleaning Engine Chute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See Fig To Replace Belts See Fig Carburetor To Adjust Cable Tension See FigTo Remove Wheels See Fig Engine Speed Fuel System StorageOther Engine OIL Troubleshooting Scrapper BAR Auger HousingKEY Part Description Auger Bearing Exploded Bearing Gearbox Assembly178675X008 Corner Bracket Clean OUT Tool Impeller Pulley Skid Plate LH Auger Assembly 30 LHAuger Assembly 30 RH Skid Plate RH 181160X431 Drift Cutter BAR Plastic Washer Chute Snow Shield Knob BlackPOP Rivet Shield Retainer Strap Rotator Head LEVER/CABLE Rotator AssemblyCable Assembly Adjustable Rotator Pivot Bracket Repair Parts Snow Thrower Model PP291E30 Handles Lower Handle Loop Handle LHLoop Handle RH Pivot Support Weldment Handle Knob SpacerKnob RED Washer 3/8 Carriage Bolt 5/16-18 X 155377 NUT 5/16-18 169675 Repair Parts Snow Thrower Model PP291E30 Drive Speed Selector AssemblyDrive Plate Assembly Rubber Ring Roll PIN 3/16 Repair PartsAxle Shaft Sprocket 427963X428 Complete LCT EngineFrame Engine Mounting Plate Idler ARM Bracket Impeller BeltTraction Belt Idler Pulley 432335X421 Repair Parts Snow Thrower Model PP291E30 WheelsWheel Assembly LH 432336X421 Safety Ignition KEY Repair Parts Snow Thrower Model PP291E30 BAG of Parts422663 DECAL, DANGER, Deflector Repair Parts Snow Thrower Model PP291E30 DecalsDECAL, Danger DECAL, Instruction Limited Warranty

REPAIR PARTS

KEY

AXLE SHAFT

ROLL PIN 3/16

SPROCKET

THRUST WASHER

BEARING

CLIK PIN

SQUARE KEY