Manuals / Poulan / Lawn and Garden / Snow Blower

Poulan 437139, 96192004302 owner manual Auger Housing, Scraper BAR, Auger Bearing, Bearing Plug

Models: 96192004302 437139

1 44

Download 44 pages 12.67 Kb

Page 24

Image 24

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PR827ES (96192004302)

AUGER HOUSING / IMPELLER ASSEMBLY

		KEY	PART	DESCRIPTION
	3 (5x)	NO.	NO.	DESCRIPTION
	3 (5x)	1	404929X421	AUGER HOUSING 27
	4 (5x)	1	404929X421	AUGER HOUSING 27
	4 (5x)	2	404932X431	SCRAPER BAR
2		2	404932X431	SCRAPER BAR
2		3	72270505	CARRIAGE BOLT 5/16−18 X .625
		4	155377	NUT 5/16−18
	01.07.002-A

2	3

		KEY	PART	DESCRIPTION
		NO.	NO.	DESCRIPTION
		1	420478	AUGER BEARING
3		2	411939	BEARING PLUG
	01.07.024-B	3	179582	SCREW 5/16−18 X 1.00
	01.07.024-B

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.

Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 24

Image 24

Poulan 437139, 96192004302 owner manual Auger Housing, Scraper BAR, Auger Bearing, Bearing Plug

Contents

Model Number Snow ThrowerSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Assembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerParts Packed Separately in Carton Remove Snow Thrower from CartonInstall Speed Control ROD See Figs Install Traction Drive Control ROD See FigsUnfold Upper Handle Install Auger Control ROD See Figs Install Discharge Chute / Chute Rotater Head See FigInstall Chute Deflector Remote Control See Figs Check Tire PressureOperation Know Your Snow ThrowerPrimer Ignition KEYMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineHOW to USE Your Snow Thrower StoppingTo USE Choke Control See Fig To Control Snow Discharge See FigUsing the CLEAN-OUT Tool See Fig To Throw Snow See FigTo Move Forward and Backward See Fig To Adjust Skid Plates See Fig Before Starting the EngineScraper BAR See Fig Check Engine OIL Level See FigSnow Throwing Tips To Start EngineBefore Stopping If Recoil Starter has FrozenMaintenance General RecommendationsBefore Each USE LubricationCleaning EngineService and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See FigTo Replace Belts See Fig To Adjust Cable Tension See Fig To Remove Wheels See FigCarburetor Engine SpeedStorage OtherFuel System Engine OILTroubleshooting Service Notes Exploded KEY Part Description Auger Housing Scraper BARAuger Bearing Bearing PlugAuger 27 LH Auger 27 RHSkid Plate LH Skid Plate RHDeflector Seal Knob BlackPOP Rivet Chute Snow Shield 419822X431 Shield Retainer StrapLEVER/CABLE Rotator Assembly Cable Assembly AdjustableCable Assembly Heat Shield Rotator HeadLoop Handle LH Loop Handle RH419797X431 Lower HandleSpacer RetainerKnob RED Handle KnobCarriage Bolt 5/16-18 X 155377 NUT 5/16-18 169675 Wire Harness Console PanelHeadlight Bezel Flood HeadlightRepair Parts Snow Thrower - Model Number PR827ES Drive Speed Selector Assembly Drive Plate AssemblyWheel HUB END PlateAxle Shaft Roll PIN 3/16Sprocket Clik PINENGINE, B&S Frame436146X421 Engine Mounting PlateImpeller Belt Traction BeltIdler ARM Bracket Idler Pulley428684 Wheel Assembly LH 432335X428432336X428 Safety Ignition KEY 193071181037 DECAL, DangerDECAL, DANGER, Deflector Service Notes Service Notes Service Notes Limited Warranty

KEY

AUGER HOUSING 27

SCRAPER BAR

KEY

AUGER BEARING

BEARING PLUG