Knob 
Rib
Groove
DInsert the elbow tube into the blower outlet. Make sure elbow tube rib is aligned with the
blower outlet groove.
DTurn clamp knob clockwise to tighten.
VACUUM TUBE ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury.
D Align the lower vacuum tube as shown. Push lower vacuum tube into upper vacu- um tube.
Upper Vacuum 
Tube
Lower Vacuum Tube
DInsert a screwdriver into the latch area on the vacuum inlet cover.
|
|
|
|
|
|
|
|
|
|
|
|
|
| Blower | |
Latch |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| Outlet | ||||
Area |
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Latch Area | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Vacuum | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Inlet Cover | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
| ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DGently tilt the handle of the screwdriver to- ward the back of the unit while pulling up on the vacuum inlet cover with your other
hand.
DHold the vacuum inlet cover open until up- per vacuum tube is installed.
Vacuum Inlet
Retaining Post
Vacuum
Inlet
Cover
DPlace the hooks on the vacuum tube on the retaining posts; pivot tube into position. Se- cure vacuum tube by turning the knob clockwise until tight.
Hooks
D When converting back to the blower fea- ture, make sure latch on the vacuum inlet cover is securely fastened.
SHOULDER STRAP ADJUSTMENT
DHold the unit as shown.
DPass the shoulder strap over your head and
onto your right shoulder.
DExtend your left arm toward the rear of the
vacuum bag.
DAdjust shoulder strap until the vacuum bag/ shoulder strap seam lies between your
thumb and index finger.
D Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly.
WARNING: You MUST make sure the tubes are secure before using the unit.
OPERATING POSITION
Eye 
Protection
BlowerVacuum
OPERATING TIPS
S While vacuuming or blowing debris, hold the unit with the muffler side facing away from your body and clothes (see illustration above).
