Poulan 530164260 Operating the Coupler, Installing Attachment Hanger, Operating Position

LOOSEN

Knob

Upper Shaft

OPERATING THE COUPLER

Your powerhead is equipped with a coupler which enables optional attachments to be installed. The optional attachments are:

MODEL:

Edger . . . . . . . . . . . . . . . . . . . . . PPB1000E Cultivator . . . . . . . . . . . . . . . . . . PPB2000T Brushcutter . . . . . . . . . . . . . . . . PPB4000C

WARNING: Always disconnect pow- erhead spark plug (or disconnect powerhead from powersource) beforeremoving or instal- ling attachments.

REMOVING ATTACHMENT CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.

1. Loosen the coupler by turning the knob counterclockwise.

Coupler

Lower

Attachment

TIGHTEN

2. Press and hold the locking/release button.

Locking/Release Button

Coupler	Upper Shaft
Lower Attachment

3.While securely holding the upper shaft, pull the attachment straight out of the coupler.

INSTALLING ATTACHMENT

1.Remove the shaft cap from the attach- ment (if present) and discard.

2.Position locking/release button of attach- ment into guide recess of upper shaft coupler.

Coupler	Primary Hole
	Guide Recess
Upper	Locking/ Attachment
Shaft	Release
	Button

3.Push the attachment into the coupler until the locking/release button snaps into the primary hole.

4.Before using the unit, tightenthe knob se- curely by turning clockwise.

INSTALLING ATTACHMENT HANGER

An attachment hanger is provided for storage whenattachment is not in use. To install hang- er on attachment:

1.Remove the shaft cap from the attach- ment (if present) and discard.

2.Press and hold the locking/release but- ton.

3.Push hanger onto the attachment until the locking/release button snaps into the hole.

OPERATING POSITION

ALWAYS WEAR:

Eye Protection

WARNING: Inspect the area before using the unit. Remove all debris and hard objects such as rocks, glass, wire, etc., that can ricochet, be thrown, or otherwise cause injury or damage during operation.

Use your blower attachment for:

S Sweeping debris or grass clippings from driveways, sidewalks, patios, etc.

SBlowing grass clippings, straw, or leaves into piles, or removing debris from corners, around joints, or between bricks.

Control air flow by directing the blower dis- charge opening down or to one side. Always work away from solid objects such as walks, large stones, vehicles, and fences.

Clean corners by starting in corners and moving outward. This will help prevent an accumulation of debris which could fly into your face.

Be careful when working near plants. The force of the air could damage tender plants.

-- 5 --