SStore unit so the blade cannot accidentally cause injury.
SStore unit indoors, out of reach of children. If situations occur which are not covered in this manual, use care and good judgment. If you need assistance, call
SPECIAL NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnor- mal swellings. Prolonged use in cold weather has been linked to blood vessel damage in
otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feel- ing in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An
SAVE THESE INSTRUCTIONS
ASSEMBLY
CARTON CONTENTS
Check carton contents for the following:
SBrushcutter attachment S Handlebar
S Handlebar mounting bracket for 1″ shaft S Handlebar mounting bracket for 7/8″ shaft S Bracket cover (2)
S Shoulder strap
S Upper shoulder strap clamp
S Lower shoulder strap clamp (with spacer tabs) S Handlebar bracket screws (4)
S Shoulder strap clamp screws (2)
S
S Large nut for installing blade S Retaining washer
S Cupped washer
S Metal shield (assembled on brushcutter at- tachment)
S Trimmer head S Plastic shield
S Wing nut (screwed onto plastic shield) S Attachment hanger
S Hex wrench
WARNING: If received assembled, re- peat all steps to ensure your unit is properly as- sembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find that parts are missing or damaged, call
TOOLS REQUIRED
SHex wrench (provided)
INSTALLING BRUSHCUTTER ATTACHMENT
CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Coupler
LOOSEN
2.Remove the shaft cap from the brushcut- ter attachment (if present).
3.Position locking/release button of attach- ment into guide recess of coupler.
4.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
5.Before using the unit, tighten the knob se- curely by turning clockwise.
Coupler | Primary Hole | ||
|
| Guide Recess | |
Upper | Locking/ | Lower | |
Release | |||
Shaft | Attachment | ||
| Button |
|
WARNING: Make sure the locking/re- lease button is locked in the primary hole and the knob is securely tightened before operat- ing the unit.
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT. To avoid se- rious injury, the barrier portion of the handle- bar must be installed as shown on the upper shaft of the powerhead to provide a barrier be- tween operator and the spinning blade. Attach handlebar mounting bracket above arrow on safety warning decal on the upper shaft (pow- erhead end of unit). Ensure handlebar is posi- tioned on mounting bracket at the end of the arrow on the handlebar decal.
NOTE: Two mounting brackets are included with this attachment. Both brackets are provided to adapt this attachment for use with power- heads that have either a 1″ (2.5 cm) diameter or a 7/8″ (2.2 cm) diameter upper shaft. The cor- rect bracket must be used to ensure that the handlebar is mounted securely to the upper shaft before use.
TIGHTEN Knob
4