ATTACH THE EXTENSION
CORD TO YOUR UNIT
Make a loop in your extension cord and attach the cord as shown. Ensure the plug and cord are firmly and fully engaged.
1.Loosen the coupler by turning the knob counterclockwise.
Upper Shaft
Coupler
Cord Retainer
Lower Attachment
LOOSEN
Extension Cord
Recessed Plug on Unit
BEFORE STARTING UNIT
Be sure to read the electrical safety information in the safety rules section of this manual before you begin. If you do not understand the electrical safety information do not attempt to use your unit. Seek help from someone that does under- stand the information or call the customer assis- tance help line at
GUIDE BAR AND CHAIN OIL
The bar and chain require lubrication. The chain oiler provides continuous lubrication to the chain and guide bar. Lack of oil will quickly ruin the bar and chain. Too little oil will cause overheating shown by smoke coming from the chain and/or discoloration of the bar. The oil output is auto- matically metered during operation. Always fill the bar oil tank before and during use as needed (capacity = 4.6 fl. oz.).
Genuine Poulan bar and chain oil is recom- mended to protect your unit against exces- sive wear from heat and friction. Poulan oil resists high temperature thinning.
If Poulan bar and chain oil is not available, use a good grade SAE 30 oil.
SNever use waste oil for bar and chain lubri- cation.
SAlways stop the unit before removing the oil cap.
WARNING: Always stop unit and dis- connect from power source before removing or installing attachments.
REMOVING PRUNER ATTACHMENT,
LINE TRIMMER ATTACHMENT OR OTHER OPTIONAL ATTACHMENTS CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.
TIGHTEN Knob
2. Press and hold the locking/release button.
Locking/Release Button
Coupler | Upper Shaft |
Lower Attachment |
|
3.While securely holding the motor housing and upper shaft, pull the attachment straight out of the coupler.
INSTALLING OPTIONAL ATTACH- MENTS
1.Remove the shaft cap from the attach- ment (if present).
2.Position locking/release button of attach- ment into guide recess of coupler.
3.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the knob se- curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Upper Locking/Release Attachment
Shaft Button
WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit.
INSTALLING ATTACHMENT HANGER
An attachment hanger is provided for storage when attachment is not in use.
To install hanger on attachment:
1.Remove the shaft cap from the attach- ment (if present) and discard.
2.Press and hold the locking/release button.
3.Push hanger onto the attachment until the locking/release button snaps into the hole.
12
