4.Insert two screws into the screw holes.
5.Secure shoulder strap clamp by tighten- ing screws with a hex wrench.
ADJUSTING THE ASSIST HANDLE
WARNING: When adjusting the as- sist handle, be sure it remains between the
coupler and the 
lower arrow (closest to coupler) on the safety label to ensure proper
balancing of unit. When adjusting the assist handle or handlebar during use of optional at- tachments, it must be repositioned between
the throttle trigger and the 
upper arrow (closest to engine) on the safety label.
1.Loosen wing nut on handle.
2.Rotate the handle on the shaft to an up- right position; retighten wing nut.
OPERATION
KNOW YOUR PRUNER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Pruner | Shaft | Assist Handle | Muffler |
|
| ||
|
| Coupler |
|
| Bar oil fill cap | Throttle Trigger | |
|
| ||
Chain |
| Spark Plug |
|
|
|
| Primer Bulb |
Bar | Bar nut | ON/OFF |
|
|
| ||
|
| Switch |
|
Attachment Hanger |
|
| |
|
| Starter Handle | Start Lever |
ON/OFF SWITCH
The ON/OFF switch is located on the trigger handle and is used to stop the engine. Move the switch to the OFF position to stop the engine.
PRIMER BULB
The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.
START LEVER
The START LEVER helps to supply fuel to the engine to aid in starting. Activate the starting
system by moving the start lever to the START position. DO NOT squeeze the throttle trigger until the engine has started and runs. After the engine starts, allow the engine to
COUPLER
The COUPLER enables optional attach- ments to be installed on the unit.
CHAIN TENSION
It is normal for a new chain to stretch during first 15 minutes of operation. You should check your chain tension frequently. See CHAIN TENSION in the SERVICE AND AD- JUSTMENTS section.
BEFORE STARTING ENGINE
WARNING: Be sure to read the fuel information in the safety rules before you be- gin. If you do not understand the safety rules, do not attempt to fuel your unit. Call
FUELING ENGINE
WARNING: Remove fuel cap slowly when refueling.
HELPFUL TIP
To obtain the correct oil mix ratio, pour 3.2 ounces of
This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic
9
