Location of shipping spacer
| Chain Brake |
Chain Brake | Nuts |
| |
| Bar Tool |
3.Turn adjusting screw on bar counter- clockwise to move the tensioning rack as far as it will go toward the front of the bar.
Adjusting
Screw
Tensioning Rack
4.Slide the bar behind clutch drum until bar stops against clutch drum sprocket.
Mount the bar
5.Prepare the chain by checking the proper direction. Without following the illustration it is easy to place the chain on the saw in the wrong direction. Use the illustration of the chain to determine the proper direction.
Tip of
Bar
CUTTERS MUST FACE IN
DIIRECTION OF ROTATION
Cutters | Depth Gauge |
Drive Links
6.Place the chain over and behind the clutch, fitting the drive links in the clutch drum sprocket.
Place chain onto the sprocket
7.Fit bottom of drive links between the teeth in the sprocket in the nose of the guide bar.
8.Fit chain drive links in to bar groove.
9.Pull the bar forward until the chain is snug in the groove of the bar. Ensure all drive links are in the bar groove.
10.Hold guide bar against the saw frame and install the chain brake.
11.Replace the chain brake nuts and tighten finger tight. Once the chain is ten- sioned, you will need to tighten chain bra- ke nuts.
CHAIN TENSION (Including units with chain already installed)
NOTE: When adjusting chain tension, make sure the chain brake nuts are finger tight only. Attempting to tension the chain when the chain brake nuts are tight can cause damage.
Checking the tension:
Use the screwdriver end of the chain adjust- ment tool (bar tool) to move the chain around the bar. If the chain does not rotate, it is too tight. If too loose, the chain will sag below the bar.
Chain Brake Nuts | Chain Adjustment |
Tool (Bar Tool) |
Adjusting the tension:
Chain tension is very important. Chain stretches during use. This is especially true during the first few times you use your saw. Always check chain tension each time before you start the chain saw.
An adjusting screw (located on the guide bar) is used to adjust the tension of the chain (see illustration).
SLoosen the chain brake nuts.
STurn adjusting screw clockwise until chain solidly contacts bottom of guide bar rail.
Guide bar
Adjusting
Screw
SUsing the screwdriver end of the bar tool, roll chain around guide bar to ensure all links are in bar groove.
7
