Tighten Loosen
chain chain
Adjusting Wheel
3.Using a screwdriver, move chain around guide bar to ensure all links are in bar groove.
4.While lifting tip of guide bar, tighten bar knob securely (clockwise). Hand tight- en only!
Bar
Knob
TIGHTEN
5.Push lever on bar knob down to return lever to closed/locked position.
WARNING: Failure to push lever on bar knob down to closed/locked position could result in serious personal injury or damage to your chain saw.
6.Use a screwdriver to move chain around guide bar.
7.If chain does not rotate, it is too tight. Loosen bar knob 1 turn (counterclock- wise); then, loosen chain by turning the adjusting wheel 1/4 turn (upward direc- tion). Retighten bar knob.
8.If chain is too loose, it will sag below the guide bar. DO NOT operate the saw if the chain is loose.
NOTE: The chain is tensioned correctly when the weight of the chain does not cause it to sag below the guide bar (with the chain saw sitting in an upright position), but the chain still moves freely around the guide bar.
WARNING: If the saw is operated with a loose chain, the chain could jump off the guide bar and result in serious injury to the operator and/or damage the chain making it unusable. If the chain jumps off the guide bar, inspect each drive link for damage. Damaged chain must be repaired or replaced.
OPERATION
KNOW YOUR CHAIN SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
| Front Hand Guard | Front Handle | |
| Starter Rope | ||
|
|
| |
|
|
| ON/STOP |
|
|
| Switch Choke/ |
| Chain | Muffler | Fast Idle |
| Lever | ||
|
|
| |
Bar | Bar Oil Fill Cap |
| |
Sprocket |
|
|
|
Hole |
| Starter Housing Fuel Mix Fill Cap Primer Bulb | |
|
| ||
8
