Poulan 545167665 FUEL SAFETY for gas powerheads, ELECTRICAL SAFETY for electric powerheads

SAlways wear heavy, long pants, long sleeves, boots, and gloves.

SAlways wear foot protection. Do not go bare- foot or wear sandals.

SSecure hair above shoulder length. Secure or remove loose clothing or clothing with loosely hanging ties, straps, tassels, etc.

They can be caught in moving parts.

S Being fully covered also helps protect you from debris and pieces of toxic plants thrown by spinning blade.

SStay alert. Do not operate when you are tired, ill, upset, or under the influence of alcohol,

drugs, or medication. Watch what you are do- ing; use common sense.

SWear hearing protection.

SNever start or run inside a closed room or

building. Breathing exhaust fumes can kill.

SKeep handles free of oil and fuel.

SKeep hands and feet away from cutting area. S Never direct discharge of material toward by- standers nor allow anyone near the area of operation. Use care in directing discharge to avoid glass enclosures, automobiles, and the

like.

FUEL SAFETY (for gas powerheads)

S Mix and pour fuel outdoors.

S Keep away from sparks or flames. S Use a container approved for fuel.

S Do not smoke or allow smoking near fuel or the powerhead.

S Avoid spilling fuel or oil. Wipe up all fuel spills before starting the powerhead.

S Move at least 10 feet (3 meters) away from fueling site before starting powerhead engine.

S Stop engine and allow to cool before remov- ing fuel cap.

S Remove fuel cap slowly.

ELECTRICAL SAFETY (for electric powerheads)

WARNING: Avoid a dangerous envi- ronment. To reduce the risk of electrical shock, do not use in rain, in damp or wet locations, or around swimming pools, hot tubs, etc. Do not expose to snow, rain, or water to avoid the pos- sibility of electrical shock. Do not use on wet surfaces. Do not handle extension cord plug or unit with wet hands.

SUse only a voltage supply as shown on the nameplate of the unit.

SAvoid dangerous situations. Do not use in presence of flammable liquids or gases to

avoid creating a fire or explosion and/or causing damage to unit.

SAvoid dangerous environments. Do not use in unventilated areas or where dust or ex-

plosive vapors can build up.

S To reduce the risk of electric shock, the powerhead may have a polarized plug (one blade is wider than the other); if so, it will re- quire the use of a polarized extension cord. The appliance plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, re- verse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the

use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If plug does not fit fully into the wall outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equip- ment plug, extension cord receptacle, or extension cord plug in any way.

STo reduce risk of electrical shock, use ex- tension cords specifically marked as suit- able for outdoor appliances having electri- cal rating not less than the rating of unit. Cord must be marked with suffix “W--A” (in Canada “W”). Make sure your extension cord is in good condition. Inspect extension cord before use and replace if damaged. Do not use a damaged cord. Cord insulation must be intact with no cracks or deteriora- tion. Plug connectors must be undamaged. The extension cord used to reach the pow- er source must be heavy enough to carry current from the power source the full length of the extension cord to the unit. An under- sized extension cord will cause a drop in line voltage resulting in loss of power and overheating. If in doubt, use the next heavi- er gauge. The lower the gauge number, the

heavier the cord.

SDo not use multiple cords.

SDo not abuse cord. Never carry the unit by the extension cord or yank extension cord to disconnect unit. To unplug, grasp the plug, not the cord. Do not use cord as a han- dle, close a door on cord, or pull cord around sharp edges or corners. Do not ex- pose cords to heat, oil, or water.

SKeep the extension cord clear of operator and obstacles at all times. Tie cord to cord retain- er and connect to recessed plug as shown in this manual to prevent damage to unit and/or extension cord and to reduce the possibility of the extension cord discon-

necting from the unit during operation.

SDo not attempt to repair unit. Inspect the insu- lation and connectors on the powerhead and extension cord before each use. If there is any damage, do not use until damage is re-

paired by your authorized service dealer.

S Do not use the powerhead if the switch does not turn the unit on and off properly. Have the unit repaired by your authorized service dealer.

SDo not use with damaged cord or plug. If powerhead is not working as it should, has been dropped, damaged, left outdoors, or

dropped into water, return it to your autho- rized service dealer for repair.

SAvoid unintentional starting of the unit. Nev- er carry unit with your finger on the switch. Be sure the switch is in the OFF position

and never touch the switch when connect- ing extension cord.

SUnplug the unit from the power source when not in use, before servicing, and when chang-

ing accessories and/or attachments.

SAvoid any body contact with any grounded conductor, such as metal fences, or pipes, to avoid the possibility of electric shock.

3