OPERATION

KNOW YOUR TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

 

Trimmer

Shaft

Assist Handle

 

 

 

Muffler

 

 

 

 

 

 

 

 

 

 

Head

Safety Label

 

Shaft Mark or Arrow

 

 

 

 

 

Shield

 

 

 

 

 

 

 

 

 

 

Spark Plug

 

Primer

 

Throttle

 

 

 

 

 

 

 

 

 

 

 

 

Bulb

 

 

 

 

 

 

 

 

 

Trigger

 

Line Limiter

 

STOP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Switch

 

 

 

 

 

 

 

Blade

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Choke Lever

 

 

 

 

 

 

 

 

 

Fuel Mix Fill Cap

 

 

 

 

 

Starter Handle

 

 

STOP SWITCH

 

 

 

CHOKE

 

 

The STOP switch is used to stop the engine. To

The CHOKE helps to supply fuel to the engine

stop the engine, push and hold the switch in the

to aid in cold starting. Activate the choke by

STOP position until the engine stops.

 

 

moving the choke lever to the FULL CHOKE

PRIMER BULB

 

 

 

position. After the engine attempts to start, move

The PRIMER BULB removes air from the car-

the choke lever to the HALF CHOKE position.

buretor and fuel lines and fills them with fuel.

Once engine has started, move the choke lever

This allows you to start the engine with fewer

to the RUN position.

 

 

pulls on the starter rope. Activate the primer

 

 

 

 

 

 

bulb by pressing it and allowing it to return to

 

 

 

 

 

 

its original form.

 

 

 

 

 

 

 

 

 

BEFORE STARTING ENGINE

 

 

cause engine damage. When mixing fuel, follow

 

WARNING: Be sure to read the fuel

instructions printed on container. Once oil is

 

added to gasoline, shake container momentarily

information in the safety rules before you

to assure that the fuel is thoroughly mixed.

begin. If you do not understand the safety

Always read and follow the safety rules relating

rules, do not attempt to fuel your unit. Call

to fuel before fueling your unit.

1-800-554-6723.

 

 

 

CAUTION: Never use straight gasoline in

FUELING ENGINE

 

 

your unit. This will cause permanent engine

 

 

 

 

 

damage and void the limited warranty.

 

WARNING: Remove fuel cap slowly

FUEL REQUIREMENTS

when refueling.

 

 

 

This engine requires the use of minimum 87

 

 

 

 

 

octane [R+M]/2 clean gasoline.

 

HELPFUL TIP

 

 

 

IMPORTANT

 

 

 

To obtain the correct oil mix

 

 

 

 

 

Use of alcohol blended fuels (called gasohol or

 

ratio,

pour 3.2 ounces of

 

 

 

using ethanol or methanol) can cause major en-

 

2-cycle synthetic oil into

 

 

 

gine performance and durability problems.

 

one gallon of fresh gas.

 

 

 

 

WARNING: Alternative fuels (not gas-

 

This engine is certified to operate on unleaded

 

 

gasoline. Before operation, gasoline must be

oline) such as E--15 (15% alcohol), E--20 (20%

mixed with a good quality synthetic 2-cycle

alcohol), E--85 (85% alcohol) are NOT classified

air-cooled engine oil designed to be mixed at a

as gasoline and are NOT approved for use in

ratio of 40:1. Poulan/WEED EATER brand

2--stroke gasoline engines. Use of alternative

synthetic oil is recommended. Mix gasoline and

fuels will cause problems such as: improper

oil at a ratio of 40:1. A 40:1 ratio is obtained by

clutch engagements, overheating, vapor lock,

mixing 3.2 fluid ounces (95 ml) of oil with 1

power loss, lubrication deficiency, deterioration

gallon (4 liters) of unleaded gasoline. DO NOT

of fuel lines, gaskets and internal carburetor

USE automotive oil or marine oil. These oils will

components, etc. Alternative fuels cause high

6

Page 6
Image 6
Poulan 952711931 instruction manual Operation