ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

INSERT

5/16 HEX BOLT

A socket wrench set will make assembly easier. Standard

wrench sizes are listed.

5/16 LOCK WASHER

(1) 1/2" wrench Utility knife

LARGE FLAT WASHER

 

(2)3/4" wrench Tire pressure gauge Pliers

When right or left hand is mentioned in this manual, it means

 

 

when you are in the operating position (seated behind the

 

 

steering wheel).

 

STEERING

 

 

WHEEL

TO REMOVE TRACTOR FROM

STEERING BOOT

 

CARTON

ADAPTER

 

UNPACK CARTON

 

 

• Remove all accessible loose parts and parts cartons

TABS

 

from carton.

TAB

 

• Cut along dashed lines on all four panels of carton.

 

SLOTS

Remove end panels and lay side panels flat.

 

 

• Check for any additional loose parts or cartons and

EXTENSION SHAFT

 

remove.

 

 

 

LOWER STEERING SHAFT

 

BEFORE REMOVING TRACTOR FROM

 

 

SKID

 

03125

ATTACH STEERING WHEEL (See Fig. 1)

FIG. 1

 

ASSEMBLE EXTENSION SHAFT AND BOOT

 

 

• Slide extension shaft onto lower steering shaft.

INSTALL SEAT (See Figs. 2 and 3)

 

• Place tabs of steering boot over tab slots in dash and

 

push down to secure.

• Remove bolt and flat washer securing seat to cardboard

 

packing and set aside for assembly of seat to tractor.

INSTALL STEERING WHEEL

Remove the cardboard packing and discard.

• Position front wheels of the tractor so they are pointing

• Connect switch to seat.

straight forward.

• Place seat on seat pan so all three (3) bottom pads

• Remove steering wheel adapter from steering wheel

are positioned over large slotted holes in pan.

and slide adapter onto steering shaft extension.

 

Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.

Assemble large flat washer, 5/16 lock washer, 5/16 hex bolt and tighten securely.

Snap steering wheel insert into center of steering wheel.

Remove protective materials from tractor hood and grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.

SEAT

SWITCH

PAD

SLOT

SEAT

PAN

TAPE

WIRING HARNESS

Fig. 2

6

Page 6
Image 6
Poulan 96042003600 manual Tools Required for Assembly, To Remove Tractor from, Carton, Before Removing Tractor from Skid