Service and Adjustments | Poulan 96042004100 specs

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 17)

•Place attachment clutch in “DISENGAGED” position.

•Lower attachment lift lever to its lowest position.

•Roll belt off engine pulley (M) and belt keepers (G).

•Remove retainer spring (K), slide collar (L) off and push housing guide (P) out of bracket.

•Remove clutch cable spring (Q) from idler arm (R).

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis pin (B) and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

CAUTION: AFTER REAR LIFT LINKS

ARE DISCONNECTED, THE ATTACH-

MENT LIFT LEVER WILL BE SPRING

LOADED. HAVE A TIGHT GRIP ON LIFT

LEVER WHEN CHANGING POSITION

OF THE LEVER.

•Slide mower out from under right side of tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE

MOWER IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINK (E) AND REAR LIFT LIKS

(C)FROM TRACTOR AND HOOK THE CLUTCH SPRING

(Q)INTO THE CABLE GUIDE ON FRONT EDGE OF LOWER DASH.

TO INSTALL MOWER (See Fig. 18–21)

Be sure tractor is on level surface and engage parking brake.

•Lower attachment lift lever to it's lowest position.

CAUTION: LIFT LEVER IS SPRING

LOADED. HAVE A TIGHT GRIP ON

LIFT LEVER, LOWER IT SLOWLY AND

ENGAGE IN LOWEST POSITION.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

G M F

Q RG

P

A E

B

C

K	D
L	D	FIG. 17

18

Image 18

Poulan 96042004100 manual Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Contents

PB22TH42YT Model General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope Operation Service III. ChildrenIV. Towing Table of Contents To Remove Tractor from Carton AssemblyUnassembled Parts Unpack Carton Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake System Operation Know Your Tractor Reverse Operation System ROS on Position Stopping See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig To USE Throttle Control D See Fig To Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control -J See Fig To Transport See Figs Before Starting the EngineReverse Operation System ROS To Operate on Hills Purge Transmission ADD GasolineTo Start Engine See Fig Automatic Transmission Warm UP Mowing Tips General Recommendations MaintenanceMaintenance Schedule Brake Operation BatteryTractor Tires Engine Muffler CleaningEngine OIL Filter Spark Plugs Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Attach Jumper Cables To Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight Bulb Fuel System StorageOther Engine OIL Troubleshooting Points Problem Cause Correction Engine dies when Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX Dentretien Remarques Limitée Garantie Dépannage DE Guide Connexions les et interrupteurs les câblage, le Vérifiez Lame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Reglages ET Revision Starter DU Commande LA Régler PourGAZ DES Commande Carburateur LE Régler Pour 29 .FIG Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE 28 .FIG FIG LA Voir Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer Pour Tondeuse DE Lame DE Mentnetraî 24 .FIG Tondeuse LA Niveau LE Ajuster Pour25 .FIG 23 .FIG 21 .FIG 19 .FIG 20 .FIG18 .FIG Tondeuse LA Enlever Pour Courroie LA ET Tondeuse LA InstallerFig Voir 17.FIG ’ALLUMAGE Bougie EntretienFig la Voir Moteur DE D’HUILE Filtre Sionmistrans LA DE Moteur Fluide AIR À Filtre’AIR Tamis LE Nettoyer Transmission LA DE Refroidissement Fig la Voir Lame LA Enlever EN Fonctionnement DE Système ET Lubrification DE Tableau Utilisation Chaque Avant Transmission LA Purger Avant ET Réinstallation LA Après Purgée ÊtreUtilisation 12 .FIG ’ESSENCE Réservoir LE Remplir E T O MO P Moteur DU D’HUILE Niveau LE Vérifier Accessoires Autres ET Charrettes DES Remorquer Pour 11 et 3 .Fig les VoirMAR EN Fonctionnement DE Système DE Régulateur LE Utiliser Comment Tondeuse LA Utiliser PourVitess Fig la S I L I T U GAZ DES Commande LA Utiliser PourE L G N a R T É L Fig la Voir Mentnetionsta DE Frein LE Engager Pour Froid moteur un démarrer de permet Détrangleur Commande ’EMBRAYAGE Tionsec la Voir Conduisant LE EN Telet MontageDesmancom des tionfonc la et PA LA DE Tracteur LE Retirer Pour Montées NON Piéces Toncar DU Tracteur LE Sortir PourR E T T a B I F I R É Sommaire En l’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre Manipulation Pentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé