UNASSEMBLED PARTS
Slope Sheet
Key
(1) Oil Drain Tube
(2) Keys
ASSEMBLY
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes.
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton.
•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.
•Check for any additional loose parts or cartons and remove.
CHECK BATTERY (See Fig. 1)
•Lift seat pan to raised position.
•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
DISCARD TERMINAL | KEPS NUT | HEX BOLT |
| ||
PROTECTIVE CAPS |
| |
|
|
TERMINAL
COVER
NEGATIVE
(BLACK) CABLE POSITIVE (RED) 
CABLE
ADJUST SEAT (See Fig. 2)
•Sit in seat.
•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.
•Release lever to lock seat in position.
A
FIG. 2
NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
03037
FIG. 1
5
