MAINTENANCE
MUFFLER
Do not operate tiller without muffler. Do not tamper with exhaust system. Damaged mufflers or spark arresters could create a fire hazard. Inspect periodically and replace if necessary. If your engine is equipped with a spark arrester screen assembly, remove every 50 hours for cleaning and inspection. Replace if damaged.
SPARK PLUG
Replace spark plugs at the beginning of each tilling sea- son or after every 50 hours of use, whichever comes first. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” on page 3 of this manual.
CLEANING
Do not clean your tiller when the engine and transmission are hot. We do not recommend using pressurized water (garden hose, etc.) to clean your unit unless the gasket area around the transmission and the engine muffler, air filter and carburetor are covered to keep water out. Water in engine will shorten the useful life of your tiller.
•Clean engine, wheels, finish, etc. of all foreign mat- ter.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•Protect painted surfaces with automotive type wax.
TRANSMISSION
Your transmission is sealed and will not require lubrication unless serviced.
SERVICE AND ADJUSTMENTS
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 15)
Factory assembly has provided lowest handle height. Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil.
•If a higher handle height is desired, loosen the four nuts securing handle panel to engine brackets.
•Slide handle panel to desired location.
•Tighten the four nuts securely.
ENGINE BRACKETS
HANDLE
PANEL
NUTS (ALSO 2
ON LEFT SIDE
OF TILLER)
FIG. 15
TINE ARRANGEMENT
NORMAL TILLING - 26" PATH (See Fig. 16)
•Assemble holes “A” in tine hubs to holes “B” in tine shaft.
CLEVIS | OUTER |
PIN | TINE |
A | A |
| |
B | B |
tine_4 |
|
HAIRPIN CLIP | INNER TINE |
FIG. 16
MID-WIDTH TILLING - 24" PATH (See Fig. 17)
•Assemble holes “A” in tine hubs to holes “C” in tine shaft.
A | C | C | A |
tine_5 |
|
|
|
FIG. 17
Your outer tines can be assembled in several different ways to suit your tilling or cultivating needs.
CAUTION: Tines are sharp. Wear gloves or other protection when han- dling tines.
12
