Poulan 96042003500, 960 42 00-35 manual

Models: 960 42 00-35 96042003500

1 44
Download 44 pages 32.48 Kb
Page 13
Image 13

OPERATION

TO OPERATE ON HILLS

WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.

To restart movement, slowly release parking brake and clutch/brake pedal.

Make all turns slowly.

TO TRANSPORT

Raise attachment lift to highest position with attachment lift control.

When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can at- tract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 7)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

Place gear shift lever in neutral (N) position.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to choke () position.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke ( ) position and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, move the throttle control to the fast position.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

13

Page 13
Image 13
Poulan 96042003500, 960 42 00-35 manual

960 42 00-35, 96042003500 specifications

The Poulan 96042003500, also known as the Poulan Pro 42cc 2-Cycle Gas Chainsaw, is a reliable and efficient tool designed for both professional landscapers and homeowners alike. This chainsaw stands out in a competitive market due to its blend of power, user-friendly features, and advanced technologies that enhance performance and comfort during operation.

One of the primary features of the Poulan 96042003500 is its powerful 42cc engine. This robust engine is designed to deliver exceptional performance, providing enough power to tackle a variety of cutting tasks, from tree trimming to felling larger trees. The 2-cycle engine is known for its efficiency, ensuring users can perform their tasks with minimal downtime.

The chainsaw is equipped with a 16-inch bar and chain, making it suitable for a wide range of applications. This size strikes a balance, allowing users to handle both small and medium-sized jobs without compromising maneuverability. The chain itself is designed for rapid cutting, contributing to the overall efficiency of the tool.

User comfort and safety have been prioritized in the design of the Poulan 96042003500. It features an ergonomic handle that provides a comfortable grip, reducing fatigue during extended use. Additionally, the chainsaw is equipped with a chain brake for enhanced safety, which stops the chain immediately in case of kickback, protecting the user from potential injuries.

The chainsaw also incorporates advanced technologies like an automatic oiling system, which ensures that the chain and bar remain adequately lubricated during operation. This feature not only extends the life of the saw but also reduces maintenance requirements. The easy-access air filter makes maintenance straightforward, allowing users to clean or replace the filter quickly, promoting better engine performance.

In summary, the Poulan 96042003500 is a versatile and powerful chainsaw that combines robust performance with user-friendly features. Its 42cc engine, lightweight design, and safety features make it an excellent choice for anyone looking to take on outdoor tasks effectively. Whether you're cutting firewood or shaping your landscape, this chainsaw stands as a reliable companion, offering the performance and comfort required for a successful job.