Auger Housing, Scrapper BAR, Auger Bearing

REPAIR PARTS SNOW THROWER - MODEL PP1053ES (96192001804)

AUGER HOUSING / IMPELLER ASSEMBLY

	3 (5x)
	4 (5x)	KEY	PART
		KEY	PART	DESCRIPTION
2		NO.	NO.	DESCRIPTION
2		1	404930X428	AUGER HOUSING
		1	404930X428	AUGER HOUSING
		2	404933X479	SCRAPPER BAR
		3	72270505	CARRIAGE BOLT 5/16−18 X .625
	01.07.003-A	4	155377	NUT 5/16−18
	01.07.003-A

2	3

	KEY	PART	DESCRIPTION
	NO.	NO.	DESCRIPTION
3	1	420478	AUGER BEARING
3	2	411939	BEARING PLUG
01.07.024-B	2	411939	BEARING PLUG
01.07.024-B	3	179582	SCREW 5/16−18 X 1.00

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 22

Image 22

Poulan 96192001804, 421918 owner manual Auger Housing, Scrapper BAR, Auger Bearing, Bearing Plug

Contents

Model Number Snow Thrower Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents EXT RA Shear Bolts and Nuts Chute Deflector Remote ControlParts Packed Separately in Carton Rotator Head Mounting Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper Handle Install Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Install Chute Deflector Remote Control See Figs Install Discharge Chute / Chute Rotater Head See FigCheck Tire Pressure Primer OperationKnow Your Snow Thrower Ignition KEY Meets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting engine HOW to USE Your Snow Thrower Stopping To Throw Snow See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Move Forward and Backward See Fig Check Engine OIL Level See Fig To Adjust Skid Plates See FigBefore Starting the Engine ADD Gasoline See Fig Before Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has Frozen Before Each USE MaintenanceGeneral Recommendations Lubrication Snow Thrower CleaningEngine Chute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See Fig To Replace Belts See Fig Storage Other Troubleshooting Exploded KEY Part Description Auger Bearing Auger HousingScrapper BAR Bearing Plug Auger Assembly 30 LH Auger Assembly 30 RH Deflector Weldment Deflector Control AssemblyChute Weldment Deflector Seal Rotator Pivot Bracket LEVER/CABLE Rotator AssemblyRotator Head Pulley Pivot Repair Parts Snow Thrower Model PP1053ES Handles Knob RED Repair PartsSpacer Handle Knob Shifter ROD TOP Impeller ROD AssemblyTraction ROD Assembly Shifter ROD Bottom Part KEY Description Repair Parts Snow Thrower Model PP1053ES Drive END Plate Speed Selector AssemblyDrive Plate Assembly Bottom PAN Axle Shaft Sprocket LH358SA-159628A KEY Part Description Tecumseh Engine Model423184X428 Engine Mount Plate Traction Belt Belt CoverImpeller Belt Repair Parts Snow Thrower Model PP1053ES Wheels Cable Bracket LH Cable Bracket RH Safety Ignition KEY Repair Parts Snow Thrower Model PP1053ES BAG of Parts35062 181037 Repair Parts Snow Thrower Model PP1053ES DecalsDECAL, Danger Service Notes Limited Warranty

KEY

AUGER HOUSING

SCRAPPER BAR

KEY

AUGER BEARING

BEARING PLUG