OPERATION
GASOLINE
FILLER CAP
MUFFLER
CHOKE 
CON-
TROL
PRIMER
ELECTRIC | AUGER | DEFLECTOR REMOTE | TRACTION DRIVE |
START BUTTON | CONTROL | ||
| LEVER | CONTROL LEVER | CONTROL LEVER |
RECOIL | DRIVE SPEED |
| |
(AUXILIARY) | CONTROL LEVER |
| |
STARTER |
|
| |
HANDLE |
|
| |
| CHUTE |
|
|
DEFLECTOR |
|
| |
|
|
| LIGHT |
SAFETY
IGNITION
KEY ON / OFF SWITCH
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
DISCHARGE
CHUTE
TOOL
FIG. 8
DISCHARGE CHUTE CONTROL 
KNOB
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
8
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control knob - used to change the direction the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
