9
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
FIG. 10
OPERATION
LH and RH turn triggers – used to steer the snow thrower.
Drive speed control lever – used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever – used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever – used to engage auger motion
(throw snow).
Discharge chute control lever – used to change the
di rec tion the snow is thrown.
Deflector remote control lever – used to change the
dis tance the snow is thrown.
Skid plate – used to adjust height of scraper bar from ground.
Drift cutter – used to cut through deep snowdrifts.
Toolbox – used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing en gine.
Primer – pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control – used for starting a cold engine.
Throttle / Engine control – used to se lect either FAST or
SLOW engine speed and to STOP the engine.
Freewheel control – disengages transmission for pushing
the snowthrower with the engine off.
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CON TROL LEVER
AUGER
CONTROL
LEVER
TOOLBOX
HANDLE
KNOB
SKID PLATE
CHUTE
DE FLEC TOR
DISCHARGE
CHUTE
AU GERS
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
LIGHT
LH TURN
TRIGGER
CLEAN-OUT TOOL
DRIFT CUTTER
FREEWHEEL
CONTROL
RECOIL
(AUXILIARY)
STARTER
HANDLE
THROTTLE
/ ENGINE
CONTROL
GAS O LINE
FILLER
CAP
ENGINE OIL CAP
WITH DIPSTICK
SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
ELECTRIC
START
BUTTON
PRIM ER
FUEL
SHUT-OFF
VALVE
OIL DRAIN PLUG
POWER
CORD
PLUG