D Disconnect spark plug before performing maintenance except for carburetor adjust- ments.
DUse only recommended Poulan PRO re- placement parts; use of any other parts may void your warranty and cause damage to your unit.
DEmpty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and letting it run until it stops.
D Do not use any accessory or attachment other than those recommended by manufac- turer for use with your unit.
DDo not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from hot water heaters, electric motors or switches, furnaces, etc.
DStore in a dry area out of reach of children.
SPECIAL NOTICE: Your blower is equipped with a temperature limiting muffler and spark arresting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require by
law that many internal combustion engines be equipped with a spark arrestor screen. If you operate a blower in a state or locale where such regulations exist, you are legally re- sponsible for maintaining the operatingcondi- tion of these parts. Failure to do so is a viola- tion of the law.
SAFETY NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or ab- normal swelling. Prolonged use in cold weatherhas been linked to blood vessel dam- age in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An antivibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condi- tion of this tool.
|
|
|
| 4 |
|
| 9 | 2 | 6 |
|
|
|
| |
1 |
| 3 |
| 5 |
| 8 |
| ||
|
|
|
|
WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in the manual and on the unit.
1.Locate and identify all components.
2.Connect the flexible tube to the outlet tube on the engine. Tighten the hose clamp.
3.Remove bottom screw from control han- dle. Install the control handle against the flared area on the base tube with the ON/ STOP switch facing the engine.
CARTON CONTENTS
7 | 1. | Outlet Tube | |
2. | Flexible Tube | ||
| |||
| 3. | Hose Clamps | |
| 4. | Control Handle | |
| 5. | Base Tube | |
| 6. | Middle Tube | |
| 7. | Air Nozzle | |
| 8. | Throttle Cable | |
| 9. | Throttle Cable Clamp |
4. Connect the base tube to the flexible tube. Tighten the hose clamp.
5. Assemble the air nozzle to the middle tube and connect the assembly to the base tube by pushing the tubes together and turning them until they lock in place.
6. Remove throttle cable clamp from flexible tube. Place throttle cable in clamp and re- install on flexible tube.
