Poulan CL36A Use Hardware - Group D, Hook front latch down into latch hole at front of mower

6	CONTAINER MOUNTING (See Fig. 6)
	No hardware required

1.Install one container to left side first with warning to outside of unit. Install other container to right side.

NOTE:Right container should always overlap left container at center support.

2.Close cover and lock latch handle over center support tube.

7	LOWER CHUTE (See Figs. 7A & 7B)
	Use Hardware - - GROUP "D"

1.	Press weld nut into rubber latch and install two latch
	hook assemblies to lower chute using screw, flat washer,
	and lock washer as shown.
2.	Tighten hardware securely.
3.	Raise and hold deflector shield in upright position.
4.	Place front of chute over front of mower deck opening
	and slide into place as shown.
5.	Hook front latch down into latch hole at front of mower

COVER LATCH

HANDLE

CONTAINER

WARNING

GNI RN WA

CONTAINER

HANDLE

82 020

FIG. 6

CENTER SUPPORT TUBE

CONTAINER WARNING

deck.

6. Hook rear latch down into latch hole at back of mower

deck.

CAUTION: Do not remove discharge guard from mower.Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.

	WASHER
02	LOCK
75
4

WASHER

LATCH

DEFLECTOR SHIELD

LATCH

WELD NUT

WELD NUT SCREW

LOCK WASHER

WASHER

024
7
	6

FIG. 7B

FIG. 7A

LATCH

HOOKS

9