2 | COVER SEAL (See Fig. 2) |
No hardware required |
1.Align mark on seal with mark at cover opening.
2.Work seal into opening so cover sits between flanges of seal.
| 6 |
08 | |
02 |
|
ALIGNMENT
MARKS
| COVER SEAL |
| FIG. 2 |
|
|
|
|
3 | SUPPORT POST (See Fig. 3) |
Use Hardware - - GROUP "B" |
1.Rotate cover assembly onto its side as shown.
2.Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely.
CARRIAGE
BOLTS
SUPPORT | 02092 |
POST |
|
| LOCKNUTS |
FIG. 3
4 | MOUNTING TO TRACTOR (See Fig. 4) |
| |
| Use Hardware - - GROUP "C & D" |
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor.
1.Raise seat on tractor to allow assembly to be mounted.
2.With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket.
3.Line up holes in mounting bracket with holes in support post and insert bracket support pin.Secure with retainer spring.
4.Unlatch and open cover.
5.Secure cover assembly to support tube using short hex bolt, long hex bolt, and locknuts as shown. Tighten all hardware securely.
NOTE: Hardware securing support tube to drawbar must be tightened at this time.
6.Install the four (4) tubing end caps onto container support. Tap each end cap onto container support tubes to seat securely.
COVER ASSEMBLY
SHORT | LOCKNUTS | |
HEX BOLT | ||
| ||
LONG |
| |
HEX BOLT | BRACKET | |
| ||
| SUPPORT PIN | |
| RETAINER | |
| SPRING |
END CAP
02090
LOCKNUTS
SHORT
HEX BOLT
LONG
HEX BOLT
SUPPORT TUBE
SUPPORT POST
MOUNTING
BRACKET
LANCED TABS
FIG. 4
8
