ASSEMBLY
UNPACK CARTON & INSTALL HANDLE (See Fig. 2)
CAUTION: Be careful of exposed staples when handling or disposing of cartoning material.
IMPORTANT: WHEN UNPACKING AND ASSEMBLING TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLE(S).
•Cut cable ties securing handles.
•The handle may be assembled in high or low position. Slowly lift handle assembly up, route cable(s) as shown and align handle holes with desired handle panel hole and slot.
•Loosely assemble hardware as shown. Be sure the shorter (3/4" long) hex bolt is assembled in lower hole of handle. Repeat for opposite side. Tighten all hardware securely.
NOTE: Cables must not touch the muffler.
•Cut cable ties securing tiller to skid and remove tiller from skid.
•Remove screws securing depth stake to skid and dis- card the screws.
NUT LOCK
WASHER
TILLER
HANDLE
HANDLE
PANEL
INSTALL DEPTH STAKE ASSEMBLY (See Fig. 3)
•Loosen nut “A”.
•Insert stake support between engine bracket halves with stake spring down.
•Bolt stake support to engine brackets with bolts, lock washers and nuts. Tighten securely. Tighten nut “A”.
•Depth stake must move freely. If it does not, loosen support bolt.
|
| ENGINE BRACKET |
|
| HALVES |
depth |
|
|
_ |
|
|
stake | NUT “A” | |
_ | ||
5 | ||
| ||
|
| DEPTH STAKE |
|
| SUPPORT |
|
| STAKE |
|
| SPRING |
|
| DEPTH |
|
| STAKE |
| HEX BOLTS, | SUPPORT |
| BOLT | |
| LOCK WASHERS, | |
| AND HEX NUTS | |
FIG. 3
s_96 dle han
FLAT
WASHER
02051
CABLE
TILLER
HANDLES
HEX BOLT
HEX BOLT
HANDLE HEIGHT
•Handle height may be adjusted to better suit operator. (See “HANDLE HEIGHT” in the Service and Adjust- ments section of this manual).
TILLING WIDTH
•Tilling width may be adjusted to better handle your tilling conditions (See “TINE ARRANGEMENT” in the Service and Adjustments section of this manual).
TINE OPERATION
HANDLE
PANEL
BOLTS
FIG. 2
•Check tine operation before first use. (See “TINE OP- ERATION CHECK” in the Service and Adjustments section of this manual).
5
