ASSEMBLY /
NOTE: The
UNFOLD UPPER HANDLE
1.Raise upper handle to the operating position and tighten handle knobs securely. Additional carriage bolts, washers and handle knobs are in bag of parts. Use to secure upper handle to lower handle. Install in lower holes in handles.
INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)
1.Remove plastic tie securing rod to lower handle.
2.Insert rod into speed control bracket and secure with retainer spring.
SPEED |
CONTROL |
ROD |
PLASTIC TIE |
UPPER |
HANDLE |
HANDLE |
KNOB |
LOWER |
HANDLE |
FIG. 1
SPEED CONTROL ROD | |
| RETAINER |
| SPRING |
SPEED | SPEED |
CONTROL | CONTROL |
BRACKET | LEVER |
FIG. 2
INSTALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4)
The traction drive control rod is installed on the snow thrower.
1.Remove plastic tie securing traction drive control rod to rotator bracket.
2.With top end of rod positioned under left side of control panel, push rod down and insert top end of rod into hole in traction drive control lever. Snap rod into place by pushing down.
NOTE: Engage lever once and rod should snap into place.
PLASTIC TIE |
TRACTION DRIVE |
CONTROL ROD |
FIG. 3
TRACTION DRIVE CONTROL LEVER |
TRACTION DRIVE |
CONTROL ROD |
FIG. 4
5