SERVICE AND ADJUSTMENTS
| BOTH FRONT PLATE LINKS MUST BE |
| • Remove screws from R.H. mandrel cover and remove | |
| EQUAL IN LENGTH |
| cover. | |
|
|
|
| • Remove any dirt or grass clippings which may have |
|
|
|
| accumulated around mandrels and entire upper deck |
|
|
|
| surface. |
| 16 |
|
| • Disconnect R.H.suspension arm from rear deck bracket |
| 025 |
|
| by removing retainer spring. |
|
|
|
| |
|
|
|
| • Roll belt over the top of R.H. mandrel pulley carefully. |
|
|
|
| • Remove belt from electric clutch pulley. |
| NUT “D” | NUT “C” | • Remove belt from idler pulleys. | |
|
|
|
| • Check primary idler arm and two idlers to see that they |
| 02517 |
|
| rotate freely. |
| TRUNNION | • Be sure spring is securely hooked to primary idler arm | ||
|
| |||
| FRONT PLATE AS- |
|
| and spring arm. |
| SEMBLY |
|
| MOWER DRIVE BELT INSTALLATION |
|
|
|
| |
|
|
|
| • Install belt in both idlers. |
|
| FIG. 22 |
| • Install new belt onto electric clutch pulley. |
|
|
| • Roll belt into upper groove of R.H. mandrel pulley care- | |
|
|
|
| |
TO REPLACE MOWER DRIVE BELT |
| fully. | ||
| • Carefully check belt routing making sure belt is in the | |||
MOWER DRIVE BELT REMOVAL (See Fig. 23) |
| |||
| grooves correctly. | |||
• | Park tractor on a | level surface. Engage | parking | • Reconnect R.H. suspension arm to rear deck bracket |
| brake. |
|
| |
|
|
| with retainer spring. | |
|
|
|
| |
•Lower mower to its lowest position.
•Disengage belt tention rod from lock bracket.
CAUTION: Rod is spring loaded. Have a tight grip on rod and release slowly.
•Reassemble R.H. mandrel cover.
•Engage belt tension rod by pushing rod into locking bracket.
|
| RH MANDREL |
|
| COVER |
| BELT TENSION | ELECTRIC |
| ROD(DISENGAGED | CLUTCH |
| POSITION) | PULLEY |
|
| IDLER |
|
| PULLEYS |
|
| R.H. |
|
| MANDREL |
| SPRING |
|
| ARM |
|
RH SUSPENSION |
| |
ARM | PRIMARY |
|
| IDLER ARM | 02513 |
|
| |
FIG. 23
22
