OPERATION

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to“START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release the parking brake and let the clutch/

brake slowly return to operating position.

•Allow one minute for transmission to warm up.This can be done during the engine warm up period.

•The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run- ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

•Place tractor safely on level surface with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly dis- engage clutch/brake pedal.

•Move motion control lever to full forward position and hold for five (5) seconds. Move lever to full reverse position and hold for five (5) seconds. Repeat this procedure three (3) times.

NOTE: During this procedure there will be no movement of drive wheels. The air is being removed from hydraulic drive system.

13

Page 12 Page 14
Page 13
Image 13
Poulan PO175H42STA manual ADD Gasoline, To Start Engine See Fig, Purge Transmission, Automatic Transmission Warm UP
Page 12 Page 14

PO175H42STA specifications

The Poulan PO175H42STA is a robust and reliable riding lawn mower designed to provide efficient mowing for homeowners with medium to large-sized lawns. This lawn tractor boasts a variety of features and technologies that enhance its performance, comfort, and ease of use.

One of the standout features of the PO175H42STA is its powerful 17.5 horsepower Briggs & Stratton engine. This reliable engine ensures efficient cutting, even in thicker grass. The engine is designed for easy starting and smooth operation, allowing for a hassle-free mowing experience.

The cutting deck of the Poulan PO175H42STA measures 42 inches, making it ideal for tackling larger areas in a shorter amount of time. The deck's design includes a reinforced frame for added durability, and it offers an adjustable cutting height, allowing users to customize the mowing experience according to their lawn's needs. With six different height settings, ranging from 1.5 inches to 4 inches, users can achieve the perfect cut for their specific grass type and desired look.

The ergonomic design of the Poulan mower also contributes to user comfort. The adjustable high-back seat provides ample support during long mowing sessions, while the soft-touch steering wheel reduces vibrations, enhancing the overall mowing experience. Additionally, the foot-operated deck lift feature allows for seamless adjustments of the cutting height without having to leave the seat, making it highly convenient.

This riding mower is equipped with an automatic transmission, providing a smooth and effortless driving experience. The user-friendly controls make it easy for individuals of all skill levels to operate the mower effectively. The front headlights improve visibility while mowing early in the morning or later in the evening, ensuring that mowing can occur at any time of the day.

In terms of maintenance, the Poulan PO175H42STA includes features that simplify upkeep. The deck wash port makes it easy to clean the underside of the mowing deck, preventing grass clippings from building up and affecting performance. Additionally, its sturdy construction promises longevity, making it a worthwhile investment for those looking to maintain a pristine lawn.

Overall, the Poulan PO175H42STA riding lawn mower combines power, comfort, and user-friendly features, making it a top choice for homeowners who value efficiency and performance in their lawn care routine.
Top Page Image Contents