SERVICE AND ADJUSTMENTS

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps:

•Loosen the adjustment bolt.

•Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.

•Tighten adjustment bolt securely.

•Start engine and test.

•If tractor still creeps, repeat above steps until satis- fied.

MOTION CONTROL

LEVER NEUTRAL LOCK GATE

ADJUSTMENT

BOLT

02239

FIG. 24

TRANSMISSION REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See“PURGETRANSMISSION” in the Operation section of this manual.

TO ADJUST STEERING WHEEL

ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 25)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR WHEEL ONLY)

FIG. 25

TO START ENGINE WITH A WEAK BATTERY (See Fig. 26)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

WEAK OR DEAD BATTERY FULLY CHARGED BATTERY

FIG. 26

REPLACING BATTERY (See Figs. 27 and 28)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acci- dental grounding.

22

Page 21 Page 23
Page 22
Image 22
Poulan PO17H42STB manual Transmission REMOVAL/REPLACEMENT, To Adjust Steering Wheel Alignment, Front Wheel TOE-IN/CAMBER
Page 21 Page 23

PO17H42STB specifications

The Poulan PO17H42STB is a reliable and powerful lawn tractor that caters to the needs of homeowners seeking efficiency and performance in their lawn care tasks. With its robust design and user-friendly features, the PO17H42STB is an excellent choice for maintaining medium to large-sized lawns.

One of the standout features of this lawn tractor is its 17.5 horsepower Briggs & Stratton engine. This powerful engine provides ample power to tackle various lawn conditions and enables smooth operation across different terrains. With a hydrostatic transmission, the PO17H42STB offers seamless control over speed and direction, allowing users to navigate their lawn with ease, without the need for manual gear shifting.

The cutting deck of the PO17H42STB spans 42 inches, making it ideal for efficiently mowing larger areas. Equipped with a dual-blade system, the cutting performance is optimized to produce a clean and even cut, reducing the need for multiple passes. Additionally, the cutting height is adjustable, providing versatility for different grass lengths and types, ensuring that your lawn maintains a healthy and attractive appearance.

Comfort and convenience are at the forefront of the PO17H42STB's design. It features an ergonomic seat, allowing for extended periods of use without discomfort. The compact size of the tractor also makes it easy to maneuver in tight spaces, ensuring that corners and edges are not neglected. Furthermore, the large, easy-to-access fuel tank and integrated storage compartment enhance the overall user experience.

Another notable characteristic of the Poulan PO17H42STB is its durability. Built with high-quality materials, it is designed to withstand the rigors of regular use while maintaining its performance over time. The tractor also features a lifetime warranty on the frame, providing peace of mind to users regarding their investment.

In summary, the Poulan PO17H42STB lawn tractor stands out with its powerful engine, efficient cutting deck, and user-centric design. With technologies that enhance both performance and comfort, this model is an excellent option for homeowners looking to keep their lawns well-maintained. Its combination of power, durability, and ease of use makes the PO17H42STB a reliable companion for any lawn care enthusiast.
Top Page Image Contents