LOWER SHOULDER STRAP
CLAMP
Spacer Tabs 
Spacer Tabs positioned for use on 1∀ diameter upper tube
1.Place the upper shoulder strap clamp over the upper tube above the handlebar.
2.Position the lower shoulder strap clamp under the upper tube and align the upper and lower clamp screw holes (use spacer tabs between upper and lower clamps if necessary to secure clamp, i.e. for 1∀ diameter upper tube).
Upper Shoulder
Strap Clamp
POWERHEAD
END
|
|
| ATTACHMENT | |
Lower Shoulder | ||||
END | ||||
Strap Clamp | ||||
Screws | ||||
|
|
| ||
3.Insert two screws into the screw holes.
4.Secure shoulder strap clamp by tighten- ing screws with the hex wrench.
5.Try on shoulder strap and adjust for fit and balance before starting the engine or begin- ning a cutting operation.
6.Insert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the right side of your waist.
NOTE: A
7.Adjust the strap, allowing the hook to be about 6 inches below the waist.
8.Fasten the strap hook to the upper clamp and lift the tool to the operating position.
Shoulder Strap
Shoulder 
Strap
Clamp
KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR BRUSHCUTTER ATTACHMENT. Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.
Locking Lever
Hanger | Tube |
|
| ||||
| |||||||
| |||||||
|
| Gearbox | |||||
|
| ||||||
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Blade |
Blade Shield |
|
|
|
|
| ||
|
|
|
|
|
| ||
BLADE
The BLADE is designed for cutting grass, weeds, and brush up to 1/2 inch in diameter.
LOCKING LEVER
The LOCKING LEVER is used to prevent the blade shaft from turning during blade replace- ment.
5
