OPERATION
DANGER:
Failure to properly ground generator can result in electrocution, especiallyif the generator is equipped with a wheel kit. National Electric Code requires generator to be properly grounded to an approved earth ground. Call an electrician for local grounding requirements
WARNING:
Do not use any attachments or accessories not recommended by the manufacturer of this generator. The use of attachments or accessories not recommended can result in serious personal injury.
APPLICATIONS
This generator is designed to supply electrical power for operating compatible electrical lighting, appliances, tools, and motor loads.
BEFORE OPERATING THE UNIT
fluid levels or adding fluid.
CAUTION:
Attempting to start the engine before it has been properly filled with oil will result in equipment failure.
OIL FILL HOLE
Full
Res
OIL DIPSTICK
Fig. 7
FUEL TANK
CHECKING/ADDING OIL
Engine oil has a major influence on engine performance and service life. For general,
NOTE:
■Unscrew the oil dipstick and remove.
■Wipe dipstick clean and reseat in hole. Do not rethread
■Remove dipstick again and check oil level. Oil level should fall within the hatched area on the dipstick.
■If level is low, add engine oil until the fluid level rises to the upper portion of the hatched area on the dipstick.
■Replace and secure the dipstick.
CHECKING/ADDING FUEL
continue with the next step.
■Remove the fuel tank cap.
FUEL TANK CAP
FUEL LEVEL
GAUGE
Fig. 8
NOTE: Always use unleaded gasoline with a pump octane rating of 86 or higher. Never use old, stale, or contaminated gasoline, and do not use an oil/gas mixture. Do not allow dirt or water to enter the fuel tank.
OXYGENATED FUELS
Some conventional gasolines are blended withalcohol or an ether compound. These gasolines are collectively referred to as oxygenated fuels. To meet clean air standards, some
15
