ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(2) | 7/16" wrenches | Utility knife |
(1) | 3/4" wrenches | Tire pressure gauge |
|
| Pliers |
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CAR- TON
UNPACK CARTON
• | Remove all accessible loose parts and parts cartons |
| from carton. |
• | Cut, from top to bottom, along lines on all four corners |
STEERING
WHEEL INSERT
1/2 HEX NUT
LARGE FLAT
WASHER
STEERING
WHEEL
STEERING
BOOT
TABS
ADAPTER | EXTENSION SHAFT |
of carton, and lay panels flat. |
• Check for any additional loose parts or cartons and |
remove. |
BEFORE REMOVING TRACTOR FROM SKID
ATTACH STEERING WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
•Slide extension shaft onto lower steering shaft. Align mount- ing holes in extension and lower shafts and install 1/4 hex bolt and locknut. Tighten securely.
1/4 LOCKNUT
LOWER
STEERING
SHAFT
1/4 HEX BOLT
TAB
SLOTS
IMPORTANT: TIGHTEN BOLT AND NUT SECURELY TO
•Place tabs of steering boot over tab slots in dash and push down to secure.
FIG. 1
HOW TO SET UP YOUR TRACTOR
INSTALL STEERING WHEEL
•Position front wheels of the tractor so they are pointing straight forward.
•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.
•Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.
•Assemble large flat washer, 1/2 hex nut and tighten securely.
•Snap steering wheel insert into center of steering wheel.
•Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.
CHECK BATTERY (See Fig. 2)
•Lift seat pan to raised position.
•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
SEAT PAN 
LABEL
TERMINAL
TERMINAL
FIG. 2
6
