SERVICE AND ADJUSTMENTS
TO REMOVE WHEEL FOR REPAIRS (See Fig. 25)
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).
•Repair tire and reassemble.
•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.
•Replace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
WASHERS
RETAINING
RING
AXLE
COVER 
SQUARE KEY
(REAR WHEEL ONLY) 
FIG. 25
TO START ENGINE WITH A WEAK BATTERY (See Fig. 26)
CAUTION:
If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the CUSTOMER RE- SPONSIBILITIES section of this manual).
If “jumper cables” are used for emergency starting, follow this procedure:
“POSITIVE” | “NEGATIVE” |
(+) | |
L.H. PANEL |
|
BOLT |
|
FIG. 26
REPLACING BATTERY (See Fig. 27)
CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,rings,etc.
Positive terminal must be connected first to prevent sparking from acciden- tal grounding.
•Lift hood to raised position.
•Remove terminal guard.
•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
•Install new battery with terminals in same position as old battery.
•Reinstall terminal guard.
•First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
•Connect BLACK grounding cable to negative
•Close terminal access doors.
•Close hood.
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable to the POSITIVE |
(+) terminal of each battery, taking care not to short |
against chassis. |
• Connect one end of the BLACK cable to the NEGA- |
TIVE |
• Connect the other end of the BLACK cable to good |
TERMINAL ACCESS DOOR
TERMINAL GUARD
KEPS NUT
HEX
BOLT
POSITIVE (RED)
CABLE
NEGATIVE (BLACK)
CABLE
CHASSIS GROUND, away from fuel tank and battery. |
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable first from chassis and then from the fully charged battery.
•RED cable last from both batteries.
FIG. 27
23
