ASSEMBLY
WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find parts missing or damaged, call
It is normal for the fuel filter to rattle in the empty fuel tank.
Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.
INSTALLING TRIMMER ATTACH- MENT
CAUTION: When installing trimmer attach- ment, place the unit on a flat surface for stabil- ity.
1.Loosen the coupler by turning the knob counterclockwise.
Coupler
Shipping
protectorLOOSEN
Knob
TIGHTEN
2.Remove shipping protector from coupler.
3.Remove the shaft cap from the trimmer at- tachment (if present).
4.Position locking/release button of attach- ment into guide recess of coupler.
5.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
6.Before using the unit, tighten the knob se- curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Locking/
Upper Release Attachment
Shaft Button
WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment instruction manual. Using the wrong hole could lead to seri- ous injury or damage to the unit.
Locking/Release
Button in Primary Hole
For assembly of optional attachments (see list on page 11), refer to the ASSEMBLY sec- tion of the applicable attachment instruction manual.
ATTACHING THE SHIELD
WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you. For proper orientation of shield, see KNOW YOUR TRIM- MER illustration in OPERATION section.
1.Remove wing nut from shield.
2.Insert bracket into slot as shown.
3.Pivot shield until bolt passes through hole in bracket.
Bracket
Shield
Slot
4.Reinstall wing nut and tighten securely. WingNut
9
