PORTABILITY KIT INSTALLATION

TOOLS REQUIRED: 7/16”, 1/2” and 9/16" sockets and ratchets, block(s) of wood (minimum of 6” tall).

Refer to the parts list on page 9.

WHEEL INSTALLATION

1.Block up end of generator opposite the fuel tank cap to install wheel kit.

2.Insert wheel spacer (item 39) into the center of the wheel (item 28).

3.Slide 3/8 x 4.25” bolt (item 32) and 3/8 washer (item 27) through the wheel (item 28), then through the wheel bracket on the carrier, with the offset side of the wheel hub against the wheel bracket.

4.Thread 3/8 nyloc nut (item 33) onto the bolt and tighten to securely clamp the wheel assembly to the carrier.

5.Repeat above instructions for the remaining wheel.

FOOT INSTALLATION

1.Assemble the rubber feet (item 29) to the foot bracket (item 43) using a 1/4-20 x 1.5” bolt (item 42). Thread a 1/4 washer (item 36) and a 1/4 nyloc nut (item 10) to the bolt to secure the assembly. Caution: Do not over tighten so that the foot material collapses.

2.Blocking up the alternator side of the generator, place the foot bracket under the carrier channel. Thread a 5/16-18 x 1” bolt (item 41) with a 5/16 wide washer (item 50) through the mounting holes and thread a 5/16 wide washer (item 50) and a 5/16 nyloc nut (item 13) to the bolt to secure the foot bracket to the carrier.

HANDLE INSTALLATION

1.Place handle (item 25) and handle bracket (item 46) on carrier on same end as feet, as shown in the diagram.

2.Slide 5/16 x 2.25” bolt (item 26) and 5/16 washers (item 12) through handle and handle bracket as shown in diagram and secure with 5/16” nyloc nut (item 13). Tighten until handle is securely clamped to the carrier.

3.Apply aerosol hairspray or similar adhesive to the handle (item 25), and then slide the handle grip (item 40) onto the handle. The aerosol hairspray will allow for easier assembly and will adhere the grip to the handle.

4.Insert cap (item 35) into end of handle (item 25).

5.Repeat above instructions for the remaining handle.

LOCKING HANDLE

1

 

 

 

 

 

 

 

 

 

2

1.

Attach the lanyards (item 30) to the release

 

 

 

 

 

 

 

 

 

 

 

 

pins (item 34) and carrier as shown in the

 

 

 

 

 

 

 

 

 

 

 

 

illustration.

 

 

 

 

 

 

 

 

 

 

 

2.

To lock the handle (item 25) in the extended

 

 

 

 

 

 

 

 

 

 

 

 

position, align the holes in the handle brackets

 

 

 

30

 

 

34

 

 

 

with the holes in the carrier brackets and insert

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the release pins (item 34).

English

 

3

 

 

 

 

Page 3
Image 3
Powermate PM0116000.01 manual Portability KIT Installation, Wheel Installation, Foot Installation, Handle Installation