Powermate PM0435004 manual Electric Start, Battery Kit Parts List, Battery Removal & Installation

ELECTRIC START

This generator model is provided with both electric start and recoil start capabilities. Avoid prolonged cranking, as it can damage the engine.

The supplied charger is capable of 4A at 12 Volts when plugged into a 120 Volt AC outlet receptacle. This can be either from the generator output or from a standard wall outlet receptacle. It can be used as a floating charger for constant charging or as a bulk charger. The indicator status tells the charge with either a Green (float) or Red (bulk) LED light. Please see the supplied Specification for further information on the charger.

The battery provided is a nominal 12 volt sealed rechargeable lead-acid battery and can be operated in any position without leakage. It complies with non-spillable battery regulations. Its convenient size offers a 30% reduction over conventional batteries.

Length = 5.94 inches, Width = 2.55 inches, Height = 4.39 inches, Weight = 7.05 lbs 10AH Rating

UL Recognized

Battery Kit Parts List
Item	Description		Qty
A.	*Bolt, 1/4-20 X 5.5”	2
B.	*Washer 5/16	2
C.	Hold down bar (P/N 0065057)	1
D.	*Nyloc nut, 1/4-20	2

*These are standard parts available at your local hardware store.

Note: Brand New Generators are shipped with the Battery Connections disconnected. The Positive and Negative Terminals must be connected to the Battery before the Electric Start Feature will work.

Initial Battery Connection - Refer to the Installation Instructions Below.

Battery Removal & Installation:

Removal: Remove the wires from the negative and positive terminals, being careful not to short across the terminals. (Shorting the terminals together can cause sparks, damage to the battery or generator or even burns or explosions.) Always abide by the safety warnings provided with the battery. Remove the battery and re-cycle and dispose of properly.

•Do not short-circuit the battery terminals.

•Do not charge in a sealed container.

•Keep sparks, flame away.

Installation:

Hook up the new battery, or re-install the new battery, as follows: Place the battery in the position provided. Connect the Red 10 Gauge wire to the positive (+) terminal and the Black 10 Gauge wire to the negative (-) terminal. Make sure all connections are tight. Your battery is now connected and ready for use. Turn the start rocker switch to the on position and push the start button to crank the engine.

Note: Be sure Oil has been added to the engine as specified in the Owner's Manual.

	English
4