Powermate PMC435001 manual Cord SET, Refer to the parts list and drawing on pages 8

PORTABILITY KIT INSTALLATION

CORD SET

TOOLS REQUIRED: 7/16”, 1/2” and 9/16" sockets and ratchets, block(s) of wood (minimum of 6” tall).

Refer to the parts list and drawing on pages 8 and 9.

WHEEL INSTALLATION

1.Block up end of generator opposite the fuel tank cap to install wheel kit.

2.Insert wheel spacer (item 43) into the center of the wheel

(item 35).

3.Slide 3/8 x 4.25” bolt (item 41) and 3/8 washer (item 38) through the wheel (item 35), then through the wheel bracket on the carrier, with the offset side of the wheel hub against the wheel bracket.

4.Thread 3/8 nyloc nut (item 42) onto the bolt and tighten to securely clamp the wheel assembly to the carrier.

5.Repeat above instructions for the remaining wheel.

FOOT INSTALLATION

1.Blocking up the engine side of the generator, place the foot bracket (item 50) under the carrier channel. Thread a 5/16-18 x 4” bolt (item 48) with a rubber foot (item 37) through the mounting holes and thread a 5/16 flange nut (item 16) to the bolt to secure the foot bracket to the carrier.

Caution: Do not over tighten so that the rubber foot material collapses.

LOCKING HANDLE

1.Attach the lanyard (item 39) to the release pin (item 44) and carrier as shown in the illustration.

2.To lock the handle (item 31) in the extended position, align the holes in the handle bracket with the holes in the carrier bracket and insert the release pin (item 44).

3.Insert caps (item 45) into ends of handle (item 31)

Your generator is supplied with a 25 foot 12 GA SJTW 4-conductor 105ºC power cord set. This cord is equipped with an L14-20P twistlock Plug, on one end, which will plug directly into the mating twistlock receptacle on the control panel of your generator. The opposite end comes equipped with a special 4 circuit connector comprised of four 5-20R receptacles. These may be used to power individual loads. Make sure the loads do not exceed the 20 amp rating of the Power Cord Set. Circuit breaker protection is provided for on the control panel of your generator.

You will notice that the 4-circuit connector is color coded with red and blue dots. When several loads are powered at the same time, it is best to keep equal loads supplied to each separately colored half, if possible. The red half and the blue half of the connector are each capable of sustaining 20 amps of current provided your generator is capable of supplying 4800 watts of power. Check nameplate ratings for total wattage capability of the generator.

1

2

English 3