S3.25 Leg Press Option Assembly Instructions
2 Preparations
CAUTION: To set up this equipment, you will need assistance. Do not attempt assembly by yourself.
You must review and follow the instructions in this guide. If you do not assemble and use the Leg Press Option according to the following guidelines, you could void the Precor limited warranty.
Required Tools
You need to obtain these tools before assembling the unit:
❑
❑
❑
❑
❑Two adjustable pliers or crescent wrenches
❑Standard set of metric Allen wrenches
❑Utility knife or scissors
❑Measuring tape
Installation Requirements
Follow these installation requirements when assembling the unit:
•Fill out and mail the limited warranty card. The warranty card is found on the back cover of this guide.
•Set up the Leg Press Option on a solid, flat surface. A smooth, flat surface under the unit helps keep it level. A level unit has fewer malfunctions.
•Provide ample space around the machine. Open space around the machine allows for easier access.
•Insert all bolts in the same direction. For aesthetic purposes, insert all the bolts in the same direction unless specified (in text or illustrations) to do otherwise.
•Leave room for adjustments. Tighten fasteners such as bolts, nuts, and screws, so that the unit is stable, but leave room for adjustments. Do not fully tighten fasteners until instructed in the assembly steps to do so.
Assembly Tips
•A
To find out the length of a particular bolt, measure its shank (the long, narrow part beneath the head). Refer to the following diagram.
•Read all caution notes on each page before completing that step.
Bolt head
| To determine the |
Bolt threads | length of a bolt, |
| measure its shank. |
Shank
•Some pieces have extra holes that you will not use. Use only those holes indicated in the instructions and illustrations.
•While you may be able to assemble the Leg Press Option by using the illustrations only, refer to the text for important safety cautions and notes.
Preparations
page 5