Precor UBK 800 warranty Side cover removal

Assembling the Exercise Bike 17

4.Remove the four #10 x 1-inch self-tapping screws holding the left side cover in place, then pull the cover away from the body assembly. Guide the cover around the pedal crank, then remove it and set it aside.

Figure 4: Side cover removal

5.Remove the tape holding the base unit data cable in place inside the upright support channel.

6.Slide the jack panel up and out of its bracket in the right side cover.

To install the upright support and prepare the cables for connection to the console:

1.Attach the lower ends of the following cables to the inner side of the jack panel:

Ethernet cable

Television cable (for P80 console)

Power cable (for P80 console)

2.Slide the jack panel back into its bracket in the right side cover.

3.Using a piece of tape or a plastic tie, bind together the upper ends of all cables.

4.While your assistant holds the upright support in place over the body assembly, thread the cables upward through the support. When you are finished, use a piece of tape to secure the upper connectors of the cables at the top of the support.

5.Slide the upright support into position so that its screw holes line up with the corresponding holes on the body assembly, as shown in the following illustration.