WARNING!
The wall should be capable of supporting a weight of at least 50 lbs. If it cannot, the wall must be reinforced. Proper installatio procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result i serious personal injury. It is strongly recommended that two people perform the installation procedures.
CAUTION! The entire installation instructions should be fully read and understood, including all of the safety symbols an safety precautions, before beginning installation. The installation instructions should be read, understood and followed to preven personal injury or property damage. Keep these installation instructions in an easily accessible location for future reference.
Indicates that the power plug is to be disconnected from the power outlet.
Safety precautions must be taken at all times.
Warning and caution in general
INSTALLATION INSTRUCTIONS
PRF
Step 1
Check that you have all the hardware listed on the front of the page. If any of the hardware described is missing on your particular model do not continue, contact PREMIER MOUNTS INC. shown on the front cover.
Separate the plates and choose the location for the monitor and follow any safety and precautions from the monitor’s manufacturer.
Single studs: For single wood studs use the two (2) middle mounting points found on the back plate. Locate the center of the wood stud behind the wall, mark the height and location desired. Drill two (2) 1/8" pilot holes on the marked wall. Secure the back plate to the center of the wood stud by using two (2) of the #10 wood screws (supplied). All electrical wiring should be done at this time use the two (2)
Solid structure: Use the four (4) mounting points on the back plate. Choose the wall where the monitor will be located. Level and mark with a pencil the four (4) mounting points found on the back plate. Drill four (4) 1/16" pilot holes for the plastic anchors then secure the wall bracket with the four (4) #10 x 1¼" screws (supplied) to the anchors. All electrical wiring should be done at this time use the two (2)
10 (mm) Phillip screws (supplied). Raise the flat panel with the front plate attached and slip the top flange opening to the flange on the back plate. Slide the monitor down slowly. Make sure the back plate flange captures the front plate top flange opening before letting go of the monitor. Slide down and push in. To secure the two plates install the two (2) M6 x 12 (mm) securing screws to the bottom of the plates using a long Phillip head screwdriver.
Recessed monitor: If you have a recessed VESA 75 the four (4) .5" nylon spacers and the four (4) M4 x 20 (mm) Phillips must be used to follow the single stud
Or the solid structure installation methods to complete the installation.
CAUTION: Do not over tighten the M4 screws to the monitor. Failure to do so could result in damaging the threads and monitor.
2
