Securing the mount
Step 5
Warning: The plasma display is heavy and 2 people are needed to lift and install it. Failure to do so could result in serious personal injury.
Before placing the plasma on the wall recheck all hardware for proper tightness and security. Before installing, become familiar with the way the plasma mount attaches to the wall mount. Align the four (4) tab openings to the four (4) receiving tabs on the flat back plate. When all four (4) the tabs are aligned slide the plasma down, right and down again to lock the mounts together. Make sure all (4) tab openings are interlocked with the receiving tabs before letting go of the plasma. See fig 5.
Caution: The plasma display is heavy and 2 people are needed to lift and
install it. Failure to do so could result in serious personal injury.
Securing tabs
Universal flat
mount
mount
Tab openings
Caution: All four (4) receiving tab openings from the mounting bracket must be locked to the tabs found on the flat back plate before letting go of the plasma display. See the diagram on the left to see the interlocked tab.
Locked tab
Align the tabs and |
|
push the plasma | Plasma display |
as shown on |
|
arrows to lock in |
|
place |
|
Wall structure
Plasma display
Wall structure
Additional security (Does not apply to flat wall mounting)
Step 6
For additional security gradually tilt the bracket forward using a Phillips screwdriver. Secure the two (2) M6 x 12 (mm) Phillips screws (screws) see fig 6. Do not over tighten the screws. Position the bracket to the desired angle.
10
