LCD Installation
1.Determine the mounting hardware that is to be used.
2.If your LCD has a flat back, use the M4x12mm Phillips Head Screws.
NOTE: If your LCD has a recessed back, use the longer M4x30mm Phillips Head Screws and 3/4” Spacers.
3.After you have determined the appropriate screws, use them to attach the mounting plate to the back of your LCD.
4.Do not
Final Installation
1.To complete the installation, simply slide the arm piece onto the back plate.
2.The plastic tab on the top of the back plate should click, indicating that the arm piece is secure.
3.If you need to remove the arm piece, push in on the tab and slide the arm up.
4.For additional security and stability, insert the hex set screw into the hole located on the side of the arm piece and tighten using the supplied Allen Wrench.
Adjustment
Knobs
Operation and Adjustment
1.Tilt angle can be adjusted by first loosening the adjustment knob.
2.Adjust the tilt to the desired level and
3.Other viewing adjustments can be made by simply moving the arm into the desired position. NOTE: If you find that a joint is too difficult to move
or does not hold the LCD in place, you can adjust the tightness of the joint. This can be done by either tightening the adjustment knob, or by using the supplied Allen wrench and tightening the elbow joint.
Elbow Joint
Slide Arm Down
Set Screw
SWINGOUT LCD TV WALL MOUNT
INSTALLATION GUIDE: XUA-1330L
Adjustment Knob
Produced By:
Progressive Marketing Products, Inc.
3130 E. Miraloma Ave.
Anaheim, CA 92806
victory@mounts.com
