Pride Mobility 1121 owner manual On/Off Key, Battery Condition Meter, Speed/Profile Keys

V I I . O P E R A T I O N

On/Off Key

The on/off key turns the VSI on and off.

WARNING! Unless faced with an emergency situation, do not use the on/off key to stop the power chair. This will cause the power chair to stop abruptly.

WARNING! Always turn the power off when you are stationary to prevent unexpected movement.

Battery Condition Meter

The battery condition meter is a 10-segment illuminated display located in front of the joystick. It consists of red, yellow, and green lights. When the lights are on, it indicates that there is power to the VSI. The lights also indicate battery status, VSI opera- tional status, and electrical system status.

!Red, yellow, and green lights lit: Batteries charged; VSI operational, and electrical system OK.

!Red and yellow lights lit: Charge batteries if possible; VSI operational, and electrical system OK.

!Red lights only lit or slow flash: Charge batteries as soon

as possible; VSI operational, and electrical system OK.

NOTE: When the batteries approach a discharged state,	Figure 27. VSI Controller Keypad
the first red light will begin to slowly flash, reminding
you the batteries need to be charged immediately!

!Rapid flash of lights: Indicates a fault in the VSI or the electrical system. Refer to “VSI Error Codes.”

!Ripple side to side of lights: The joystick was not in the neutral position when the controller was turned on. If you get “ripple side to side of lights,” turn off the controller, allow the joystick to return to the neutral position, then turn on the controller.

NOTE: If you still get “ripple side to side of lights,” contact your Quantum Rehab Specialist.

Speed/Profile Keys

The speed/profile keys control either the speed setting or the drive profile. Press the speed/profile increase key to increase the speed setting or change the drive profile to a higher number. Press the speed/profile decrease key to decrease the speed setting or change the drive profile to a lower number. The speed setting or drive profile is displayed on the maximum speed/profile indicator. If your power chair was programmed with a drive profile, contact your Quantum Rehab Specialist for more information.

NOTE: We recommend that the first few times you operate your power chair, you use the lowest speed setting until you become familiar with your new power chair.

Quantum1121 www.quantumrehab.com 33