![](/images/new-backgrounds/1199975/19997551x1.webp)
V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 17.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Turn off the power to the controller.
2.Unplug the controller connector(s) from the power base.
3.Cut the wire tie(s) securing the controller harness to the armrest.
4.Flip up the armrest and loosen the setscrew. See figure 17.
5.Slide the controller out of the armrest.
6.Loosen the setscrew in the other armrest.
7.Place the controller in the other armrest.
8.Tighten the setscrews in each armrest.
9.Secure the controller harness to the armrest with wire ties.
10.Plug the controller connector(s) into the power base.
NOTE: If your power chair is equipped with a TRU- Balance Seating System, refer to the controller adjust- ment information contained in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several different heights.
To raise or lower the foot platform:
1.Remove the hardware from the foot platform bracket. See figure 18.
2.Loosen the foot platform securement nut
3.Raise or lower the foot platform to the desired height.
4.Reinstall the hardware into the foot platform bracket and tighten.
5.Tighten the securement nut.
CONTROLLER
BRACKET
SETSCREW
Figure 17. Underside of Armrest
SECUREMENT NUT |
FOOT PLATFORM BRACKET |
Figure 18. Foot Platform Adjustment
26 | www.pridemobility.com | Jazzy 614 Series |