V . C O M F O R T A D J U S T M E N T S

Seat Position

You can move the seat forward or backward by changing the seat base mounting position.

To change the seat position:

1.Turn off the power to the controller.

2.Make sure the power chair is in drive mode.

3.Unplug the controller connector(s) from the power base.

4.Remove the seat from the power base.

5.Remove the screws and washers from the bottom of the seat plate. See figure 9.

6.Slide the seat plate forward or backward, aligning the holes in the plate with the corresponding holes on the seat base. You must move both sides of the seat forward or backward the same number of holes.

WARNING! Changing the position of the seat can cause instability. Do not change your seating configuration without first contacting Pride Mobility Products or your authorized Pride Provider.

WARNING! After any adjustments, repairs, or service and before use, make sure that all attaching hardware is tightened securely to prevent injury and/or equipment damage.

7.Reinstall the screws and washers to the seat plate and tighten the hardware firmly.

8.Reinstall the seat.

9.Reconnect the controller to the power base.

SEAT BASE

SEAT PLATE

WASHER

SCREW

WARNING! The center of gravity of your power chair was factory set to a position that meets the needs of the demographic majority of users. Your authorized Pride Provider has evaluated your power chair and made any necessary adjustments to suit your specific requirements. Adjusting the seat position can cause instability. Do not change your seating configuration without first contacting Pride Mobility Products or your authorized Pride Provider.

Figure 9. Seat Position Adjustment

14

www.pridemobility.com

Jazzy Elite 6

Page 14
Image 14
Pride Mobility Elite 6 manual Seat Position, To change the seat position